Zentralanstalt für Meteorologie und Geodynamik Atmospheric stability in urban areas detected by ultrasonic anemometers Martin Piringer, August Kaiser
Mar 28, 2015
Zentralanstalt für Meteorologie und Geodynamik
Atmospheric stability in urban areasdetected by ultrasonic anemometers
Martin Piringer, August Kaiser
Zentralanstalt für Meteorologie und Geodynamik
04/10/23
Martin Piringer
Folie 2
The problem – and a solution?
Commercially available dispersion models widely used in air pollution assessment
They are usually fed with conventional meteorological
data (wind and stability – discrete stability categories)
Meteorology measured at air pollution monitoring stations run by local governments – instrumentation sometimes not properly placed
Aim: Improvement by 3D ultrasonic anemometersboth with respect to placing as well as data
Zentralanstalt für Meteorologie und Geodynamik
04/10/23
Martin Piringer
Folie 3
Outline
Site and instrumentation
Comparison of wind data: air pollution monitoring station against ultrasonic anemometer
Advanced determination of atmospheric stability by 3D sonics against discrete stability classes
Results of dispersion modelling for an industrial complex in an Alpine valley – conventional vs. 3D sonics input data
Zentralanstalt für Meteorologie und Geodynamik
Area of investigation
04/10/23
Martin Piringer
Folie 4
U: ultrasonic anemometerR: RASSD, L, G: Air Pollution Monit. Stations of Local GovernmentP: Representative up-valley site (no pollution monitoring)
Zentralanstalt für Meteorologie und Geodynamik
Measurement locations
04/10/23
Martin Piringer
Folie 5
Air pollution monitoring station D Ultrasonic anemometer at U
Zentralanstalt für Meteorologie und Geodynamik
Comparison of wind speed
04/10/23
Martin Piringer
Folie 6
Site D: High frequency of weakwinds, especially at night; main wind directions deflected fromvalley axis
Site U: valley wind system; along-valley wind directions show largest average speeds
Zentralanstalt für Meteorologie und Geodynamik
Comparison of wind direction
04/10/23
Martin Piringer
Folie 7
Site D, all winds
Site D,winds > 0,7 ms-1
Site U, all winds
Zentralanstalt für Meteorologie und Geodynamik
Atmospheric stability by 3D ultrasonic anemometers
Atmospheric stability characterized by MOS (= 1/L) derived via algorithm based on Stull (1988) made available by the manufacturer of the instrument
Necessary because uncorrected MOS shows large variations in time
u* from co-variances xz and yz (from wind measurements) and
smoothed over 1,5 hours From Hf (smoothed over 1,5 hours) and Tsonic,corr MOS is derived:
MOS = (-0,37 * 9,81 * Hf)/(1,292 * 1005,0 * (Tsonic,corr + 273,16) * u*3
MOS not defined for very low values of u*
04/10/23
Martin Piringer
Folie 8
Zentralanstalt für Meteorologie und Geodynamik
Sensible heat flux and MOS
04/10/23
Martin Piringer
Folie 9
Daytime: heat flux larger in summer
Nighttime: larger heat flux in winter Explanation: influence of external heat sources
Daytime: positive MOS due toshading by valley sidewalls
Nighttime: External heat sourceslead to more unstable situations in winter
Zentralanstalt für Meteorologie und Geodynamik
Example: time series of MOS
Black dots: uncorrected MOS; green dots: corrected MOS
04/10/23
Martin Piringer
Folie 10
Zentralanstalt für Meteorologie und Geodynamik
Discrete stability classes
04/10/23
Martin Piringer
Folie 11
Wind from site D, cloudinessfrom nearest airport:No unstable cases at night(per definition)
MOS and wind at site U:Frequent occurrence of unstablesituations, also at nightUrban effect?
Zentralanstalt für Meteorologie und Geodynamik
Features of the dispersion model LASAT
LASAT is a Lagrangian particle dispersion model(Janicke Consultants, Germany)
LASAT includes a diagostic wind field model, realistic flow simulation in complex terrain
LASAT includes also a building module to simulate flow around and behind buildings (not used here)
Point, area, and line sources included Example:
Yearly averaged concentration fields of PM10 and SO2caused by over 40 different sources within the industrial complex; one-year time series of met. data from sites D(with cloudiness from nearest airport) and U
04/10/23
Martin Piringer
Folie 12
Zentralanstalt für Meteorologie und Geodynamik
Annually averaged PM10 concentrations
04/10/23
Martin Piringer
Folie 14
Zentralanstalt für Meteorologie und Geodynamik
Annually averaged SO2 concentrations
04/10/23
Martin Piringer
Folie 15
Zentralanstalt für Meteorologie und Geodynamik
Conclusions
If properly placed, 3D sonics measure strength and direction of valley wind system without immediate influence by obstacles
In built-up areas, measurements have to be taken above approx. twice the average building height to be representative
3D ultrasonic anemometers enable on-site determination of wind and stability and are therefore to be preferred over conventional sensors, but:• Extremely sensitive to local conditions at the site:
Influence of heated/cooled roofs and external heat sources
• „Ideal“ position of sensor not easy to find
• Uncertainty in the determination of L/MOS in conditions of low wind speeds
04/10/23
Martin Piringer
Folie 16