This is a simple? guide to installing a Provent 200 Oil Vapour Filter into a Nissan X-Trail T31 Diesel 09 Model M9R Engine YOU PERFORM THIS MODIFICATION AT YOUR OWN RISK It may affect your warranty The author accepts NO RESPONSIBILITY Tools/Skills Required/Costs One Provent 200 CCV Oil Vapour Filter $195.00 10mm Spanner/Socket Directional tin snips (Aviation Snips) 90mm Hole saw (optional) Bracket template – This is included on the last page as a document to be printed out on A4 paper Materials for the bracket (This bracket uses 2mm Sheet Aluminium) $5-00 10mm drill bit and Drill 5/8 heater hose cut to the following lengths $7-00 (You will have to buy 2 mtrs) 1 @ 890mm 1 @ 470mm 1 @ 250mm 2 @ 75mm NOTE Hose used here is just standard water heater hose it will break down and go soft over a period of years due to oil – To use the correct oil resistant piping will cost approximately $200-00 more (Your Choice) Sharp knife for cutting hoses 3 off “Vultail” 5/8 double barbed corners – These are suitable for oil and rated to withstand 100 degrees Cel. $21-00 Irrigation fittings are no good RTV Silicone – Gasket Silicone that is oil compatible 2 small flat head nails ½ inch long and a clearance drill bit to suit Basic sheet metal skills Optional extras One espresso coffee machine! One bottle of Rum (Medicinal purposes- Antiseptic/Anaesthetic for cuts) Typist Note (YEAH RIGHT!) The clearance to the underside of the bonnet is about 7mm when measured with plasticine Step 1 Shape, Cut, Drill the bracket being careful to remove all sharp edges as per template and shown below