Summary This is a scaled down version of the Rubber Duck made by Wille on Thiniverse. I have added a flat bottom and a hole for a 10*3mm magnet It is recommeded to glue the magnet with some CA glue into the hole. If your prints have an elephant foot inside the inner hole, take a sharp knive end remove the burr - then the magnet is press-fit Household > Kitchen fridgemagnet fridge duck Unassociated tags: rubber duck Category: Kitchen & Dining Print Settings Rafts: Doesn't Matter Supports: No Resolution: 0,15 or better Infill: 10% recommended Notes: Print in PLA, ABS, PETG or any other material. No infill needed, if the shell is at least 3 layers thick, otherwise us 10% infill. WHerzog Rubber Duck Fridge Magnets VIEW IN BROWSER updated 17. 11. 2019 | published 17. 11. 2019 3D MODEL ONLY