Summary I needed a home for my Ambient controller PCB for 3Dprinter enclosures. So I made this box. https://www.youtube.com/watch?v=DbXVjOoNJw4 I had a few requirements : Fit inside IKEA LACK table and not be higher then 1cm. Give me some 3D design and print practice (don't go the easy way ;) Fit my PCB (of course) Have plenty holes to fit cables from different directions. Easy to tinker with the whole setup for debugging and modding ( room to connect a usb cable and easy access to reset button. Have some kind of awesome factor then just a boring box. Springs : Can use both elastics/rubber bands (of 1mm diameter) or ballpoint springs (i stretched them a little bit to give the box a bit more oeuuhmf! But this is not needed.) Bolts : M3 (4x >=22mm, 12x 8mm) M2 (8x 5mm) Want to build this whole project? I hope to try and make my first inscrutable post, but for now this is what you need : 1x this box 2x Popup sensors : https://www.prusaprinters.org/prints/5140-pop-up-sensor-module- adafruit-sht31d-temperature-a 2x servo controlled aperture : https:// www.prusaprinters.org/prints/5122-servo-automated-iris-aperture-for-air- flow-control 1x UI front panel : yet to upload 1x PCB with code ( I don't know yet how to share this, but give me a poke, I'm planning on making a AcE Krystal Ambient Control - PCB brain box VIEW IN BROWSER updated 17. 8. 2019 | published 17. 8. 2019 3D MODEL ONLY