33 33 31 34 circle 32 30 1 2 3 4 Each propeller by the two adhesive Sliced into propeller blade angle required Each side of the fuselage is made by a double bond Note proeller support bracket holes Pay attention to the hole of propeller’s support bracket Note that the main beam of the wing bending Note jack’s position Note jack’s position Jack on the wing below the main beam Jack on the wing below the main beam Note the bending of wing’s main beam Propeller assembly bracket (making 2 sets) Note the leading edge of the socket Assemble pilots card bit Do not plug the wing between pillars Note the direction of the wing between the strut Jack on the wing below the main beam Assemble the wing’s main beam and wing ribs Completed main beam of the wing 2pcs unnumbered wing ribs combo unnumbered wing ribs unnumbered wing ribs unnumbered wing ribs Wing Tip Wing Tip Completed main beam of the wing Main beam of the wing(right) Wing’s main beam (bottom right) Wing’s main beam (bottom left) Wing’s main beam (bottom left) Connection of wing’s main beam Fuselage/Top wing A combination of the propeller drive chain Two unnumbered ribs combination use only in the middle of the wing,each of the main wing only need one.Unless specially marked ribs,all the rest ribs are unnumberesd. Installation for the leading edge and trailing edge of the wing. 1 2 6 6 5 5 5 5 3 3 4 4 26 25 Note the bending of wing tip must be consistent in lower wing 21 15 21 22 23/24 19 28 27 29 20 Wright Flyer I INSTRUCTION MANUAL The Wright Brother’s 1903 Wright flyer