VTR1004 DIGITAL VIDEO RECORDER USER GUIDE Thank you for purchasing this Digital Video Recorder. Before using the Digital Video Recorder, please ensure that you read and understand this USER GUIDE. Please store the USER GUIDE in an easily accessible location. Before connecting and installing any third party cameras, monitors, alarms and computers, please refer to the appropriate instruction manual for proper operation. VER 2.2.3 1 st Edition
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
VTR1004
DIGITAL VIDEO RECORDER
USER GUIDE
Thank you for purchasing this Digital Video Recorder.
Before using the Digital Video Recorder, please ensure that you
read and understand this USER GUIDE.
Please store the USER GUIDE in an easily accessible location.
Before connecting and installing any third party cameras, monitors,
alarms and computers, please refer to the appropriate instruction
manual for proper operation.
VER 2.2.3 1st Edition
2
3
SAFETY PRECAUTIONS
CAUTION RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
Power disconnection. Unit with or without ON-OFF switches
have power supplied to the unit whenever the power cord is
inserted into the power source; however, the unit is operational
only when the ON-OFF switch is in the ON position. The power
cord is the main power disconnect for all units.
When the vehicle is in parking mode, the DVR continues to drain
battery. The DVR requires its own separate battery.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
4
TABLE OF CONTENTS
■ PRODUCT CONTENTS
■ INTRODUCTION
1. FRONT PANEL 8
2. REAR PANEL 9
■ POWER ON/OFF
1. TURNING ON THE POWER 11
2. TURNING OFF THE POWER 11
■ MAIN MENU
1. MENU SYSTEM 12
1.1. SELECTING THE MENU 12
1.2. POSITIONING THE YELLOW COLOR HIGHLIGHT 12
1.3. SETTING AN OPTION 12
1.4. SPECIAL BUTTON FUNCTION 12
2. ENTERING AND EXIT FROM MAIN MENU 13
2.1. ENTERING THE MAIN MENU 13
2.2. EXIT FROM THE MAIN MENU 13
3. MAIN MENU 14
3.1. DEVICE 14
3.1.1. CAMERA 14
3.1.2. ALARM 15
3.2. RECORD 16
3.2.1. GROUP 16
3.2.2. MANUAL 16
3.2.3. EVENT(MOTION, ALARM) 17
3.2.4. OVERWRITE 20
3.2.5. STORAGE 20
3.2.6. AUTO BACKUP 21
3.2.7. SCHEDULE 22
3.3 NETWORK 24
3.4. SYSTEM 25
3.4.1. SYSTEM TITLE 25
3.4.2. PASSWORD 25
3.4.3. DATE/TIME 26
3.4.4. CLEAR DATA 26
3.4.5. RESET CONFIG 26
3.4.6. SYSTEM UPGRADE 26
5
3.5. LOG LIST 27
3.6. INFORMATION 27
3.7 SHUTDOWN 27
■ SYSTEM OPERATION
1. LIVE MODE 28
1.1. STATUS BAR ON/OFF 29
1.2. CONFIGURATION UPLOAD/DOWNLOAD 29
1.3. LOG LIST DOWNLOAD 29
1.4. EVENT DATA BACKUP WITHOUT MONITOR 29
2. RECORD MODE 30
2.1. MANUAL RECORD MODE 30
2.2. EVENT RECORD MODE 31
2.3. SCHEDULE RECORD MODE 32
3. SEARCH & PLAYBACK MODE 33
3.1. SEARCH MODE 33
3.2. PLAYBACK MODE 35
4. INSTANT BACKUP 35
■ PC CLIENT SOFTWARE
1. INSTALLING PROCEDURES 38
2. PC CLIENT OVERVIEW 41
3. LOCAL BUTTONS 41
4. PLAYBACK CONTROL BUTTONS 42
5. TIME AND DATE DISPLAY 42
6. TO CONNECT THE DVR OVER THE NETWORK 43
7. LOCAL FUNCTIONS 44
8. LIVE FUNCTIONS 45
9. LIVE MONITORING 46
10. REMOTE SETUP 47
11. REMOTE SEARCH & REMOTE BACKUP 48
12. USB BACKUP 49
13. SEARCH BACKUPED FILES FROM YOUR PC 50
14. NETWORK UPGRADE 52
■ VIDEO CONVERTER
■ LOGLIST VIEWER
■ APPENDIX
6
PRODUCT CONTENTS
● SYSTEM UNIT
4 CHANNEL DIGITAL VIDEO RECORDER
● ACCESSORIES
Make sure that the following accessories are included.
In case that the product is defective or damaged, please contact your dealer.
Please keep the packaging materials for transport purposes.
① User guide
② Camera Cable
③ Software CD
④ Signal Ground Cable
WARNING
• Don’t turn off the power or unplug the power cord while hard disk drive is in
operation.
• Don’t apply vibration or shock when HDD drive is in operation. It might cause data
loss or failure.
⑤ USB Cable
7
INTRODUCTION
This Digital Video Recorder is powerful and cost-effective.
User Friendly Interface
Easy on-screen system setup and operation.
Detailed on-screen display record status, storage usage, date, time, power loss,
video loss, alarm status and camera title.
High Performance
Highly stable embedded Linux operating system.
Highly stable database management
Superior picture quality : more than 450 TV line recording
Instant backup to CF card
Fast backup through USB 2.0 with PC client S/W.
Multi functional network based system
Real time live view and playback across the network
Environmental Stability & Reliability
Compact size and light weight
Dimension: 210x145x43mm
Weight: under 1Kg
Low Power Consumption: Avg. 6 ~10 Watts
Ventilation
Anti-Vibration
Anti-Shock
Wide Temperature range.
8
1. FRONT PANEL
● Buttons (1~9)
1. NUMERIC Buttons (1~4)
Used to select the camera number
2. RECORD Button (REC)
Press it to start recording, and once again to stop. A password is required to stop
recording. The orange LED is on when the recording is in progress.
3. SEARCH Button (SER)
Press it to search the recorded image data.
4. FUNCTION Button (Fn)
Used in combination with other buttons, it allows you to access the special functions.
Refer to page 13 for detail.
5. ESCAPE Button (ESC)
Press it to cancel or exit from selected modes and menus.
6~9. ARROW Buttons ( )
These are used to move the highlight or to change the option in menu.
10. MENU/ENTER Button ( )
This button brings up the menu, and then functions as “ENTER”.
● LEDs (11~14)
11. POWER: The green LED indicates power.
12. REC (RECORD): The orange LED indicates that the record is on going.
13. ALARM: The red LED indicates that the ALARM is detected or the system failed.
14. LAN: The orange LED indicates that the system is connected to the network.
2
1 6
4
10
7
11 8
9
13 12
3
14
5
9
2. REAR PANEL
1. POWER: Main Power ON/OFF switch
2. DC POWER IN
This 12 mm circular type jack accepts the DVR power module plug or other right
positive source of 10~30V DC at 3 amperes.
3. RS-232 Connector
4. Signal Ground Terminal (SIGNAL GND)
5. ALARM IN/OUT
- :
10
(Remark) Video Input Connector Specification
1 CHANNEL
1: VIDEO GND
2: VCC GND
3: VIDEO SIGNAL
4,5: VCC
6: AUDIO SIGNAL
7,8: AUDIO GND
2,3,4 CHANNEL
1: VIDEO GND
2: VCC GND
3: VIDEO SIGNAL
4,5: VCC
6,7,8: NC
11
POWER ON/OFF
1. TURNING ON THE POWER
① Make sure that peripherals are properly connected.
② Switch「ON」on the rear panel. The front POWER LED will light up in green. Please
wait approximately 50 seconds until it start up.
< LIVE DISPLAY SCREEN >
2. TURNING OFF THE POWER
① In the LIVE mode, press the MENU/ENTER button, and then it goes to MAIN MENU.
② Select SHUTDOWN and press the MENU/ENTER button, and then the password
pop-up window is displayed as below. Enter administrator’s password and press
MENU/ENTER button. It allows you to turn off the system safely.
< SYSTEM SHUTDOWN POP-UP WINDOW >
④ Switch「OFF」on the rear panel.
NOTE
If the covert is set to「ON」in the camera settings, no camera image is displayed.
NOTE
There is no default password at factory default. Press MENU/ENTER button again
when password pop-up window is displayed.
12
MAIN MENU
1. MENU SYSTEM
The on-screen menus allow you to set up all the features.
All setup data is safe from power loss and stored in the hard disk.
1.1. SELECTING THE MENU
Press the MENU/ENTER ( ) Button to select a menu item.
If you press the ESC button, it returns to the previous menu.
1.2. POSITIONING THE YELLOW COLOR HIGHLIGHT
Use up and down buttons to position the menu highlight.
Press left and right buttons to move to the next value in the selected menu.
1.3. SETTING AN OPTION
Press left and right buttons to change the option if it is between < and > marks.
Press up and down buttons if there are no marks.
1.4. SPECIAL BUTTON FUNCTION
● Fn+ESC button: Returns to Live screen mode immediately from anywhere in the menu.
● Fn+Right button: Turns ON/OFF the status bar when in the Live screen mode.
● Fn+Left button at single channel display: Start camera sequence and display
the cameras in quad mode from single camera view in the LIVE screen mode. (Toggle)
● Fn+Up button: Upload configuration file in the LIVE screen mode.
● Fn+Down button: Download configuration file in the LIVE screen mode.
● Fn+Up/Down button in numeric setting menus: Increase/Decrease the
number by 10.
● Fn+Enter button at live display: Event data backup without Monitor.
● Fn+”1” button at live display: Shutdown Hot Key.
* It runs on LIVE screen mode. If status of DVR was recording when press
“Fn+1” button, automatically recording will be started at next booting.
13
2. ENTERING AND EXIT FROM MAIN MENU
2.1. ENTERING THE MAIN MENU
< PASSWORD POP-UP WINDOW FOR ENTERING THE MAIN MENU >
① Press MENU/ENTER button. Password pop-up window is displayed.
② Press MENU/ENTER button after entering administrator’s password. Then the MAIN
MENU screen is displayed.
< MAIN MENU SCREEN >
2.2. EXIT FROM THE MAIN MENU
Press ESC button for returning to the previous mode.
Or press Fn+ESC button together to return to LIVE screen mode immediately from
anywhere in the menu.
NOTE
There is no default password at factory default. Press MENU/ENTER
button again when password pop-up window is displayed.
14
3. MAIN MENU
3.1. DEVICE
CAMERA and ALARM can be configured in this menu.
< DEVICE MENU SCREEN >
3.1.1. CAMERA
< CAMERA MENU SCREEN >
Firstly, press the NUMERIC Button (1~4) to select a desired camera.
① TITLE: The camera title can be up to 9 characters.
- Press MENU/ENTER button and press the UP/DOWN button to select the character.
② BRIGHTNESS / CONTRAST: Adjusts brightness and contrast.
- When positioned to BRIGHTNESS / CONTRAST, press MENU/ENTER button,
pop-up window is displayed. Press the left button to reduce, and right button to