VSOF-OUTLET-A-2C VISSEM OTB-2C OUTLET-Manual Rev.0 TEL: 82-31-288-3484 FAX: 82-31-283-7844 All rights reserved by VISSEM Electronics Co. Ltd. 1. Marking a Cutting Point Mark a sheath removing point on the cable with a piece of tape at a 70cm point from the cable cut end. 2. Sheath Removing Remove the cable sheath from the marked point by using a sheath stripper. Component List Items Unit Q’ty Cable Tie EA 4 Splice protection Sleeve EA 2 Holder Gasket EA 1 Spiral Tube EA 1 3. Cutting Aramid Yarn Cut off the aramid yarn. 4. Inserting Drop Cable Pass the drop cable through the main body drop cable port to the cable cut end. 5. Fixing Drop Cable By using drop cable holder, insert each drop cable into the drop cable holder. 6. Preparation Pigtail Remove leave a 50cm pigtail by using a sheath Cutter 7. Splicing Splice fibers in accordance with splicing method to be approved. 8. Fixing Splice Protection Sleeve After the splice, insert the splice protection sleeve in each slit accordingly. 9. Routing Drop Cable Route drop cable them into stacked main body Routing the Drop cable 10. Pigtail Connection Connect the pigtails to the adapters. Route pigtail into stacked main body OUTLET-2C User Manual
2
Embed
VSOF-OUTLET-A-2C1]_Manual.pdf · 2015-04-13 · VSOF-OUTLET-A-2C VISSEM OTB-2C OUTLET-Manual Rev.0 TEL: 82-31-288-3484 FAX: 82-31-283-7844 All rights reserved by VISSEM Electronics
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.