PANORA – Ottavia Tagliavini Skype virtualtoura360 email: [email protected] Mobile +39 334.6590292 www.panora.eu easyPANORA – Virtual Tour software http://easy.panora.eu “The easiest way to create Virtual Tour by yourself” 1. Take the 360° pictures Take the 360° pictures using the 0-360 Lens and the Canon Powershot G10 or G11, Dial Mode on C1. Download them on your computer and rename them (ex. "livingroom" etc.). 2. UnWrapper: cut the pictures Cut (open) the 360° pictures using the free software “UnWrapper”, you can download it here: • if you have PC http://www.panora.eu/easy/prova/0-360-UnWrapper32-pc.exe • if you have MAC http://www.panora.eu/easy/prova/0-360-UnWrapper32-mac.zip Click on the Lens icon on your Desktop (0-360 UnWrapper) to open the software. Click “Add File(s)”, select all the pictures, click “Next>”, center the "target". Than move the larger red circle until the external picture’s border is in the middle of it, do the same with the smaller red circle (the internal picture’s border must be in the middle of it), as you can see in Pic. 1 in the next page. Now click again “Next>”. The first time you use UnWrapper, you need to select “Manual Center Selection” and “Skip Image adjusting Steps” (Pic. 1). Select the sheet “JPEG (Java Viewer)” and set “Quality” on “70” (Pic. 2you have to do it just the first time you use the software, the next times it’s saved) and click “Next>”. You'll find the cut panoramic pictures in the same folder of the 360° original pictures, with file names ending with “_0360” (max size must be 1024KB / 1MB each).