Two / 2 Ram Baler American Baler builds two ram baler models that are suitable for most paper, plastic and non-ferrous metal baling applications. If you are a paper, plastic and/or non-ferrous metal recycler American Baler will have a two ram baler models that will meet your needs. Plus we offer the best baler warranty in the business! Two Ram Baler Features • available with either a 43” wide frame or 60” wide frame • several charge box opening lengths • single side sheet construction • Meets all Current ANSI Z245.51 Safety Standards • Allen Bradley IEC components • EPAct TEFC Motors 460/3/60 - X Line Starting • Sequenced motor start-up with Economizer to shut down motors when not in use • Allen Bradley CompactLogix PLC • Panelview Touchscreen operator interface • Across-the-line conveyor motor starter (up to 10HP) and controls to optimize production • UL Approved NEMA 12 Electrical Enclosures • Operator controls mounted in MCC • Dual Infrared Cycle Control (Diffused) • Laser positioning • Pressure Transducer • Remote VPN Internet access • Left hand or right hand eject available • Manifold hydraulics with Regen • Hi-Lo vane pumps • Versa-Door w/transducer • Dual Infrared Cycle Control (Diffused) • Shimmable Serrated AR Shear Blade • Shear Beam Mounted at 9° Rake • Trunnion mounted main and eject cylinders • Full Main Ram Penetration • Hopper Access Door w/Safety Switch • Adjustable ram hold down bars • High/Low Floor • Replaceable Hardox 500 Floor and Ram Liner Strips alternating ½” to 1” • Replaceable ¼” Hardox 500 charge box side liners and press box side and top liners • Replaceable Hardox 500 Platen Strips • Bale table to support ejecting bale • Air-to-oil cooler • Tank Heater • Hot & Low Oil Shutdown • L & P Pinnacle II or Accent 470 Wire Tier • Dust Cover for Wire • 1 - Stem of Galvanized Wire (11 or 12 Ga.) • Surface is painted with an industrial primer and 2 coats of industrial enamel. • Anchor clips • Optional 12.4 or 18.8 ton hydraulic stamper at shear • Four power unit sizes depending on the ram cycle time and hourly production required