This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
TOYOTA CAMRY 2010 - EC REARVIEW MIRROR Preparation
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the "Accessory Installation Practices" document. This document covers such items as:-
(n) Attach mirror harness ring terminal to ground bolt and reinstall.
Fig. 3-13
10mm Ground Bolt
10mm Socket
Fig. 3-11
E3
Blue Wire Pin #8 +12V Acc
Fig. 3-12
TOYOTA CAMRY EC REARVIEW MIRROR Procedure
Page 8 of 10 pages
Fig. 5-2
Compass Button
On / Off Button HomeLink®
Buttons
LED Indicator Light
Fig. 5-1
(o) Secure EC mirror harness wire to OE wire bundle in cowl area with one (1) tie wrap. (Fig. 3-14)
4. Reconnect Negative Battery Cable.
(a) Reconnect the vehicle’s negative battery cable. (Fig. 4-1)
(1) Tighten the nut to 4.1 N-m (36 lbf-in).
(2) Do not touch the positive terminal with any tool when replacing the cable.
5. Testing.
(a) HomeLink® Feature:
(1) Push in HomeLink® switches, one at a time. Verify that the LED Indicator light is red when each switch is pushed. (Fig. 5-1)
NOTE: The owner of the vehicle will need to program HomeLink®
. See the HomeLink® programming instructions or visit the HomeLink® website at www.homelink.com.
(b) Turn ignition switch to ON.
(c) With the vehicle in a fairly well lit area, perform the following test:
(d) Auto Dimming Feature:
(1) To make sure the auto-dimming feature is on, verify that the LED indicator light is on. If it is not on, push the "On/Off" button to turn the LED on.
(2) Cover the forward-looking light sensor located on the back of the mirror with a dark cloth or towel. (Fig. 5-2)
Fig. 4-1
Torque Wrench, 10mm Socket
90
Battery
Battery
Negative Battery Cable
Tie Wrap
Fig. 3-14
TOYOTA CAMRY EC REARVIEW MIRROR Procedure
Page 9 of 10 pages
(3) In a few seconds, the mirror will begin to darken (time may vary with ambient light levels).
(4) Remove the cover from the forward-looking light sensor and the mirror will begin to clear.
(e) Compass Feature:
(1) Push the Compass button to turn the compass on/off. Compass is enabled when a direction or a "C" appears in the mirror display window. (Fig. 5-3)
(2) Turn ignition OFF.
6. Final Assembly.
(a) Re-install overhead console.
(b) Place the operation instruction card in the vehicle glove box.
(c) Remove fingerprints, smudges, dirt, etc. from mirror and windshield with Household Windex.
(1) When cleaning with Household Windex, follow the manufacturer’s directions. Do not allow cleaner to air dry.
(d) Verify each reinstalled component for proper fit and function.
Fig. 5-3
Compass Display Window
Compass Button
TOYOTA CAMRY EC REARVIEW MIRROR Checklist - these points MUST be checked to ensure a quality installation.