This is NUUO NUUO IO Device IO Device
Dec 29, 2015
This is
NUUONUUOIO DeviceIO Device
Install IO Device
IO Card
Capture Card
IO BoxConverter
USB RS485 RS485
RS485PCI
PCI
MPEG-4 Series
H.264 Series
• Open Main Console > Config > Setting > I/O Device1. Module Setting• Enter Module name of device• Choose Device model
– Refer IO Box or IO Card
• Set COM Port of device– My computer > manage > Computer management
> Device Manage > Ports (COM & LTP)
– It’s will show Prolific USB-to-Serial Comm Port (COM3)
• Set ID of device– Right Check on Device and choose properties >
Port Setting > Check Bits per second (Baud Rate)
It will get Baud rate
– Use Tool “IOConfig.exe” to get ID information
– Input COM port, Baud rate, and set Starting address from “0”.
– And click “scan” to search.
– The Address “0” will show as below
Right Click
2. I/O Device List• Show device already installed in system• Choose device
3. Device Setting• Modify name• Set I/O state
– N/C : normal Close
– N/O : normal Open
4. Digital input Monitor• It will become red when
signal input
5. Digital output simulation• Click to send output signal• It will become red