The new licence structure Foundation Licence Interm ediate (A) Interm ediate (B) Full(A) Full(B)
Mar 30, 2015
The new licence structure
Foundation Licence
Intermediate (A) Intermediate (B)
Full (A) Full (B)
Post WRC03If Morse is abolished
FoundationFoundation
IntermediateIntermediate
FullFull
Foundation Syllabus
Based on an entry level to Amateur Radio
Course aimed at some 10 to 12 hours
Capable of being completed in a weekend
or run over several evenings
Intermediate Syllabus
Will consist of a practical element
and a theory element.
Practical is construction project
of candidates choosing
Intermediate Syllabus
Almost complete
Anticipated in about 2 week time
Published in time for Pilot Courses
Intermediate SyllabusTimescales
Pilot Courses start in 4 - 6 weeks time
Course should last 20 - 25 hours depending on practical element
Aim for Go-Live date of 1 March 2003
there are still factors which could cause delay
Intermediate Syllabus
Theory covers a little bit more than the Novice course,
but only a little.
Foundation Pass will be a pre-requisite
Intermediate Exam
Exam set by RA
Provided and marked on-site, on-demand
Exam provider out to tender,
decision in a couple of weeks.
40 Questions 1 hour - probably
Training Courses
Same Format as Foundation
Lead Instructor must be registered
RSGB is registration body on behalf of the RA
Existing “Novice” Instructors able to cover both Foundation and
Intermediate training
Training Courses
A registered instructor leads the course and may appoint deputies
Candidates register for training with an instructor and are given a “Record of
Achievement” card
Competencies signed-off as achieved
Full Licence
Syllabus will be reviewed during 2003 to minimise overlap with Intermediate.
Introduced early in 2004 when passes at Foundation and Intermediate level will
be pre-requisites to sit exam.
Intermediate Syllabus
1. Nature of Amateur Radio
Know the various types of amateur licence. Foundation, Intermediate, Full
and recognise their call-signs.
Intermediate Syllabus
2. Licensing Conditions
Operators, Messages
Location and Identification
Unattended Operation
Log, Apparatus
Licence, Licence Schedule
Intermediate Syllabus
3. Technical Basics
Units of measurement and multiple/sub-multiple prefixes.
Simple circuit theory, Cells and Batteries
Capacitors, Inductors, Tuned Circuits
Transformers, Diodes and Transistors
Circuit Symbols, Measurements
Intermediate Syllabus
4. Transmitters and ReceiversSimple Block Diagrams of a Transmitter.
RF oscillators, Mixers
Modulation and Sidebands
Transmitter Interference
Simple Block Diagram of Receivers
Intermediate Frequency, Frequency Selection
Detectors, AGC
Intermediate Syllabus
5. Feeder and Antenna
Feeder Basics
Feeder Characteristic Impedance
Antenna Impedance
Standing Waves
Antenna Tuning Unit
Antennas, Dummy Loads
Intermediate Syllabus
6. Propagation
Radio Propagation Basics
Ionosphere basics
Intermediate Syllabus
7. EMC
Basics of Electromagnetic Compatibility
Good Radio Housekeeping
Interference Sources and Simple Remedies
Social Issues of Interference
Intermediate Syllabus
8. Operating Practices and Procedures.
Q Code
Abbreviations
RST Code
Relative Advantages of CW ssb and fm
Other Modes
Good Operating Practices
Intermediate Syllabus
9. Safety
Soldering
Use of Hand Tools
Working at Heights
Electricity
RF
Intermediate Syllabus
10. ConstructionRecognise Components
Soldering Basics
Colour CodePractical Skills
Construction
Simple Frequency Calibration
Intermediate Syllabus
Good soldered joints.
Construct a simple circuit (test set).
Measure voltages and currents in a simple circuit.
Demonstrate a diode will only conduct in one direction.
Demonstrate that a transistor can be used as a switch.
Fit a suitable RF connector (PL259,BNC or N-type) to a piece of coaxial cable.
Fit a 13A plug to a piece of 3-core mains cable.
Intermediate Syllabus
Construct a simple amateur radio related project (e.g. direct conversion receiver, crystal calibrator,
‘grid’ dip meter, ATU & SWR meter, Morse oscillator, audio amplifier) either from a pre-
prepared kit or from a published or personal design. Construction may be carried out either within a
course or elsewhere but the assessor must be satisfied that the bulk of the work is that of the
candidate.
Intermediate Syllabus
Calibrate a variable frequency oscillator (vfo) employing an adjustable LC circuit.
Calibration to show the relevant amateur band edges.
The vfo may form part of the project to satisfy the constructional item or be part of a
previously constructed project or be provided by the assessor.
Intermediate Syllabus
Note: If the candidate is disabled in any way that reasonably prevents the carrying out of any practical procedure then he/she may talk another person through the task
or describe it to the assessor. The assessor may judge “disabled”.
Any Questions