The Electromagnetic Properties of Electric Guitar Pickups Dan Carson, Prof. Steve Errede University of Illinois at Urbana-Champaign Image courtesy of .

The Electromagnetic Properties of Electric

Guitar Pickups

Dan Carson, Prof. Steve Errede

University of Illinois at Urbana-Champaign

Image courtesy of http://upsenglish.files.wordpress.com/2009/01/electric-guitar-365-2-703153.jpg

Introduction• Pickups consist of several

thousand turns of thin copper wire wrapped around 6 magnetic poles.

• Pickups convert the mechanical vibrations of the guitar string into an electrical signal.

• The goal of this project is to understand the underlying physical processes at work in electric guitar pickups.

Image courtesy of http://www.electric-guitar-info.com/electric-guitar-pickups.html

• Correlating the physical and tonal properties allows us to build better sounding pickups.

4-parameter pickup model

( ) ( )L L LZ R i

( ) ( )C C CZ R i

L(f) C(f)

RL(f) RC(f)

• Single coil pickups can be modeled as LR_CR circuits.

• Lumped parameter model (i.e., all capacitive effects are lumped into the parameter C).

• Information about the electromagnetic properties of the pickup is contained in the frequency dependence of the 4 parameters.

Extracting the Parameter Values • Complex current and voltage data were measured across

the pickup from 5-20005 Hz in 10 Hz steps.

• Matlab least squares fitting program finds the values of the 4 parameters that minimize the square of the difference between the measured and calculated values of 16 constraints (power, impedance, current, and voltage, each with real and imaginary components, magnitude, and phase) at each data point.

• Redundant constraint equations were used to minimize the adverse effect of noise in the impedance data on the least squares fitting.

Converts output of function generator into a near constant current source

Measures complex voltage

Controls function generator

Sets frequency/amplitude of pickup excitations

Converts analog signals from the lock-ins to digital signals to be sent to the PC

Stores data

Measures complex current

• Complex impedance measurements and least squares fitting was carried out for several Gibson P90 pickups in the following configurations:

bare coil

coil + magnetically permeable materials

coil + magnetically permeable materials + magnets

complete pickup (w/ cover and base plate)

• Extracting the parameter values (L, C, RL, and RC) for each of these configurations revealed a lot of interesting physics!

Gibson P90 pickup configurations

Least Squares Fit Parameter Results

Results of the least squares fit parameters for a 1952 Gibson BR-9 Lap Steel P90 pickup.

• Resistance in inductive branch obeys power law (~f2).

• RL increases when magnetic materials are added, due to magnetic dissipation.

• Data is not reliable in the f < 100 Hz range, uncertainties are too large.

Resonances in Capacitance Data• Peaks appear in the C data in the 200-1000 Hz range only when magnetically permeable materials are added to the pickup.

• The magnetic domains of the magnetic materials can be modeled after a simple harmonic oscillator.

i i ioD D Dk m

• If the damping is small, the resonant frequency of the ith sized domain is

• The size of the resonances therefore should be proportional to the

number density ni of the ith sized domain. That’s what we believe we are seeing in the data!

Effective Relative Magnetic Permeability• By definition, the effective permeability is the ratio of the

inductance when magnetic materials are present to the inductance of the

• A pickup is not a perfect inductor, so we can only calculate the effective relative permeability (i.e., only a fraction of the magnetic flux created by the pickup magnets couples to the magnetically permeable materials).

effrel relf f f

effrel mag coilf L f L f

Our results (above) agree qualitatively with the complex permeability of single crystal magnetite (left).

Our results at very low frequencies (i.e., f < 100 Hz) are unreliable due to the large uncertainties in the fit parameters at these frequencies.

Permeability Results

Image courtesy of: Craik, Derek J. Magnetism: Principles and Applications. San Francisco: Wiley, 1997.

Future work• Investigate the origin if the ~f2 dependence of the

RL parameter.

• Take data in finer (1 Hz) steps and with less noise in order to better resolve the resonances in the C data.

• Investigate possible ways to on the expand the current model.

Image courtesy of http://upload.wikimedia.org/wikipedia/commons/d/de/Super_Humbucker_V-2_pickup_on_an_Ibanez_Studio_electric_guitar.jpg

Acknowledgments

I would like to thank Lance Cooper and Celia Elliot for their help and support, and Prof. Steve Errede for his guidance throughout the project