This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
2016Technical Training Courses
* Understanding lubrication* Understanding viscosity* Principles and basics of hydraulics* Pumps, gear, screw, vane piston* Check and other poppet valves* Flow control valves* Pressure control valves* Directional control valves
* Hydraulic schematics* Hydraulic safety
* Learning about hydraulic system components with catalogues
* Identifi cation, inspection and testing of components* Understanding component characteristics* Assessment of performance against specifi cations* Localising component and system faults* Repair and / or replacement of faulty components* Selection of appropriate repair and / or replacements
* Intermediate hydraulic knowledge for technicians and supervisors
* Operation of compound relief valves, and system pressure controls
* Learning about fi xed and variable displacement pumps* Pump controls, including pressure compensation, remote
operation, load sensing and power control* Hydraulic calculations, including area, pressure, fl ow, force,
power, cycle times and line sizes
* Accumulators - general introduction* Accumulator thermodynamics and calculations* Accumulator pre-charge and test* Accumulator certifi cations and approvals* Legal requirements for owners of pressure vessels* Accumulator Simulation Software (ASP)* Hands on - accumulator assembly, test and charge
* Re-assembly and testing of components against specifi cations
* Writing and maintaining service reports and records
* Circuit design for a simple system (i.e. one actuator)* Learning about hydraulics through the use of 19
ISO 4406* Filter construction and placement* Measuring contamination* Filter sizing with manual calculations* Filter sizing with Filter-IT software* Understanding contamination
Basic Hydraulics 1 - (3 days)MEM30010A Set up Basic Hydraulic Circuits
Maintain Hydraulics 2 - (3 days)MEM18020B Maintain Hydraulic System Components
Intermediate Hydraulics 3 - (5 days)
Accumulators - (3 days)Understanding and Applications
Hydraulic System Cleanliness & Microscopic Analysis - (4 days)
For more information on courses and pricing, please email [email protected]. Alternatively, check our web site: www.hydac.com.auNOTE: All training courses refer to activities hosted at HYDAC TRAINING CENTRE, Melbourne Australia.
2016Technical Training Courses
* Selection of appropriate sensors* Installation of sensors* Maintain and diagnose sensors* Plan corrective action* Analyse open and closed control loops such
as P.I.D.
* System design using the unique HYDAC Hydraulic Power Unit system
* Assembly and testing of Hydraulic Power Units
* A practical approach to learning about hydraulic systems and fundamentals with eighteen specially developed exercises on our state of the art HYDAC training rigs
* Basics of electric and electronic control* Electro-hydraulic operation* Practical exercises using hard wired logic* Practical exercises using a programmable logic
controller (PLC)* Proportional and servo valve theory
* Overview of cooling in fl uidic systems* The importance of thermal optimisation* Learning about thermal degradation of the
system fl uid* Construction of coolers: Air blast, shell and
tube, plate, gasket and chillers* Design limitations of different cooler types