Stream Bank Stabilization Options and Techniques Rob Cronauer Watershed Specialist January 22, 2016
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Stream Bank Stabilization Options and Techniques
Rob Cronauer
Watershed Specialist
January 22, 2016
Options• #1 Rip-rap
• #2 Rip-rap
• #3 Rip-rap
• #4 Rip-rap
• #5 Other
Rip-Rap
• The #1 used stream stabilization method…and for good reason…..it works!
• Choose proper size
• Install correctly
• There are some right and wrong ways to install
Not recommended to place rip-rap on layer of fabric
The fabric can “tent” allowing water behind it. Can be very strong such as a bed sheet catching a falling person.
Prevent erosion around and/or under rip-rap• Use large enough rock the stream can’t move
• “key” the rock into the stream bed
• “key” the rock into the upstream and downstream embankments, similar to bridge abutments
• Greatest stream velocity is at the toe of the slope
Mowing as close as possible to stream banks prevents woody vegetation and roots to stabilize the bank. The vertical bank on left will never become stabilized.
Would have preferred a more gentle slope but septic system was here
Place largest stone on the “face” of the rip-rap placement, where the greatest velocities are.
Chinking/choking in the voids between the angular stones helps “knit” them together. Use the largest size possible that will still find the voids in the rocks.
Jacobs Creek,
Laurellville
BEFORE
Jacobs Creek, LaurelvilleJacobs Creek,
Laurelville
1 year after
project
Jacobs Creek, Laurelville
R-7 keyed into the bank
“chocked with 2b”, and
trees planted on top of
slope, willow stakes on
slope
3 years AFTER
construction
No room to slope back bank because of the house
Stream won’t move this size rock. Rock keyed into stream bed. Rock above stream will stabilize entire bank. Stream will erode gravel bar. Rock sloped into creek to achieve maximum slope for stability.
Mowing as close as possible to stream banks prevents woody vegetation and roots to stabilize the bank. The vertical bank on left will never become stabilized.
Banks have been sloped back to establish vegetation on the banks and the rocks are at the toe, where the greatest velocities exists
Mowing as close as possible to stream banks prevents woody vegetation and roots to stabilize the bank. The vertical bank on right will never become stabilized.
Rock at toe of slope only needed on outside bend in the creek
Achieving vegetation on banks is crucial to stabilization, and should be a priority immediately after excavation. Erosion control matting can help in this process and can help prevent erosion if the stream should floodbefore grass can become established.
Shupe Run, Willows Park,
Mt.Pleasant
BEFORE
Shupe Run, Willows
Park, Mt. Pleasant
AFTER
Rock toe with fill and
live stakes
Gabion baskets
• don’t use
• If you have to use them, the greatest chance for failures are from erosion at the start of them, beginning of them, or at the bottom of them
• Must have them embedded into the stream bed and banks, to prevent velocity from getting behind or under them
The stream couldn’t move the rocks, but could erode out from under and around them
Rock deflectors installed to maintain velocity throughout channel to reduce sediment deposition
Dredging is a temporary solution to a permanent problem.Try to reduce the sediment loading from the source. If that can’t be accomplished increase channel capacity or modify flow.
Some other techniques rather than rip-rap• Stone structures, log structures, bank grading, etc…
• More pleasing to the eye with a more “natural” look
• Can often use on-site materials
• Design for fish habitat
• Should you desire, there are alternatives to rip-rap
Can be modified into a pond intake
Haymaker Run, Murrysville
Log cross vane, used for a
pond intake, see 4”pvc on
left downstream log
Mowing as close as possible to stream banks prevents woody vegetation and roots to stabilize the bank. The vertical bank on left will never become stabilized.
Notice the velocity “white water”
is at the ends of the logs and
well away from the bank
Mill Creek, Ligonier
BEFORE
Cut leaning trees
Mill Creek,
One year after construction
Mill Creek
AFTER
Multi-log deflectors
installed, one rootwad, and
live stakes on slopes, and
trees on top of slope
Mill Creek
Sediment deposits “building bank”
after first storm
Mill Creek, Ligonier
BEFORE
Mill Creek, Ligonier
Rootwads one year after
construction
Mill Creek
2 years AFTER
Rootwads installed
Many, many more options
• If your going to use rip-rap keep in mind a few keys. Use large enough rock, embed into banks and stream bed, consider choking with smaller rock. *use oversize rock in urban settings
• If your looking for an alternative to rip-rap, options are endless. I would be happy to help out.
THANK YOU!• Rob Cronauer (724) 837-5271
Related Documents
