Using the correct lubrication before each swage operation is essential for mechanical splicing. Due to lubrication, the material in the swaging process flows much easier and helps form a tighter fit around the wire rope. See picture opposite: Sample 1; Dies have not been properly greased. Sample 2; Both upper and lower die have been coated with SPLICING GREASE. Our testing has shown a reduction of up to 20% less load when lubricants are used, leading to an enhanced die service life. It also helps avoid the splice sticking in dies after swaging, saving valuable time. - No jam - Less load - Longer service life For our environment: • Less energy to swage • Food processing safe The importance of lubrication TECHNICAL DATA SPLICING GREASE Art. No: 1 litre TALUGREASE 1L 5 litres TALUGREASE 5L 20 litres TALUGREASE 20L Information of ingredients Chemical name (CAS)/EG No. Conc. Paraffin oil, pharmaceutical (80424-70-5) 70-90 % Polybutene (900-29-6) 10-30 % Naphta (petroleum), hydrogenated light 265-149-8 (64742-47-8) 1<10 % TALURIT is a trademark owned by Talurit AB. All unauthorised use is prohibited. Splicing grease TALURIT™ TALURIT™ – Here with an efficient splicing lubricant Talurit AB · Amalia Jönssons gata 29 · 421 31 Västra Frölunda · Sweden · VAT SE556343720001 Phone +46 31 709 30 80 · Fax +46 31 47 10 71 · [email protected] · www.talurit.com TALURIT is a trademark owned by Talurit AB. All unauthorized use is prohibited. Rev. 2009-09-07 © 2014, Talurit AB