Solwise Ltd www.solwise.co.uk [email protected]ZyGMA7 Outdoor Wirelss Backbone Series 2010/07/01 Long-haul Wireless, from 2km to 30km Cost-effective Solution For Remote IP Surveillance, Backhaul for campus, farm and factory, Rural Area for Internet Connectivity, Headquarter and Br anches of Enterprise, P2P/P2MP, Village, Oil well, Inter-Island Communications, Ha rbor, Airport, Mountain Area, Industrial/ Plant Environment, Mining Solwise Ltd www.solwise.co.uk [email protected]
37
Embed
Solwise Ltd [email protected] ZyGMA7 Outdoor Wirelss Backbone Series 2010/07/01 Long-haul Wireless, from 2km to 30km Cost-effective.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
2010/07/01Long-haul Wireless, from 2km to 30kmCost-effective SolutionFor Remote IP Surveillance, Backhaul for campus, farm and factory, Rural Area for Internet Connectivity, Headquarter and Branches of Enterprise, P2P/P2MP, Village, Oil well, Inter-Island Communications, Harbor, Airport, Mountain Area, Industrial/Plant Environment, Mining
– IP67 with Built-in Panel Antenna– Up to 40km per hop– LOS– Super mode to 108Mbps– WMM Support (QoS)– Antenna Alignment Tool– Buzzer for Installation Setting– SNMP, SSH and Web Interface– GPS Coordinate Setting– Time Zone setting & Daylight Setting– PoE
– Product Package• Backbone R1(or R2) with integrated 23dBi antenna ×1• Mounting Kit ×1• PoE Injector & Power cord ×1• Grounding Wire with Screw ×1• Water Proof RJ-45 Connector Kit ×1• Quick Installation Guide ×1• Product CD ×1
If there is a tree between the two nodes, then the antenna should be installed at a higher location to avoid the tree obstacle, trying to calculate the height roughly by the Fresnel Zone formula.
• Antenna Alignment Tool– A very useful feature using BEEP frequency when your are
adjusting the antenna• Link Test• Broadcast SSID
– Hiding network name is necessary when you are in a wireless environment that may have potential risk. By disabling broadcast SSID, the STA cannot scan and find the IEEE 802.11a/n Wireless Outdoor CPE, so that malicious attack by some illegal STA could be avoided.
• If there are a lot of smog and fog, when such extreme conditions, how to overcome the throughput degrade problem with the transmission of data getting slower– technically speaking, the transimission effectiveness is a function of (System
Transmission Power) + (Antenna Gain) - (Media Loss)– When it's foggy, it means that the (Media Loss) getting bigger. There are som
e ways to improve it:• Use an antenna with bigger (Antenna Gain). But, bigger the antenna gain, sm
aller the beam angle• Increase the (System Transmission Power): it means that you should use som
ething like external Booster.• You may use additional Z9000R2 as a relay in between the two Z9000R1 that
it will shorten the hop-distance and get better throughput.• Use some devices running at 700MHz or 900MHz band. Essentially, the lower
the band frequency the signal is, the higher the signal penetration. The problem is that you need to change all the system, and the 700/900MHz may be the licenced band in your country. Furthermore, you need to have field-trial to know the exact effectiveness.
Point-to-pointCSMA up to 5km distanceTDMA up to 10km distanceLOSThe coverage angle of the built-in antenna is 10 degreeThe bandwidth should be well calculated for IPCAM application
Point-to-Multi-pointUp to 10km distanceLOSThe coverage angle of the built-in antenna is 10 degreeThe bandwidth should be well calculated for IPCAM application
Implementation Notice:Connect HQ-F1 as a multi-hop backbone networkConnect HQ-F2 as a multi-hop backbone networkEach hop is installed with distance 10kmWe need to find mid-point to install the R2, with LOS for each hop and power-system at each mid-pointThe distributed TDMA mode should be enabled for the long distance transmission.No Link Aggregation, throughput is estimated at 10~12Mpbs
• The throughput between HQ-F1 (or HQ-F2) may be estimated at 10~12Mbps (NOTE: it is very dependent on the installation settings and tuning. It is not guaranteed, field test is needed)
Implementation Notice:Connect HQ-F1 as a multi-hop backbone networkConnect HQ-F2 as a multi-hop backbone networkEach hop is installed with distance 10kmWe need to find mid-point to install the R2, with LOS for each hop and power system at each mid-pointThe distributed TDMA mode should be enabled for the long distance transmission.Link Aggregation is enabled, throughput is estimated at 18~21Mpbs
• Surveillance Video Streams• Leased-Line Backup or Replacement• Backhaul for campus, farm and factory• Rural Area for Internet Connectivity• Headquarter and Branches of Enterprise:P2P, P2MP • Cost-effectively providing long distance backhaul for remote areas• Village• Oil well• Inter-Island Communications• Harbor & Airport• Mountain Area• Industrial/Plant Environment• Mining• multi-media streams• Playing as a relay connecting different networks