Slider Indoor Banner Stand —QUICK INSTRUCTIONS STEP3 Slide the graphic to side poles STEP1 Grab 2 of the poles with the capped tops and screw on the feet to the bottom of the poles using a screw driver. Tighten very well STEP6 Grab the other long pole (top pole) and slide it through the top pole pocket STEP4 Slide bottom pole (connected with 3 pole parts) to the bottom pole pocket STEP5 Unscrew and lift up the foot poles a little bit to open up the holes on the bottom of the pole near the feet. STEP2 Make sure to extend the side pole to open the hole to screw the pole in step 5. • 2 - 3 Piece expandable Poles with Top and bottom screw holes • 2 - 3 Piece expandable Poles with bottom screw hole and capped top • 2 Feet • 6 Hand tightening screws • 1 Graphic (for graphic order)