C. Ren University of Rochester Laboratory for Laser Energetics 46th Annual Anomalous Absorption Conference Old Saybrook, CT 1–6 May 2016 Simulation of Stimulated Brillouin Scattering and Stimulated Raman Scattering in Shock Ignition 1 Transmitted laser intensity at n = 0.17 n c (from HLIP) 1 1.0 1.5 2.0 2.5 3.0 3.5 5 9 Incident intensity (×10 15 W/cm 2 ) Transmitted intensity (×10 15 W/cm 2 ) 13 17 21 T e = 3.5 keV, T i = 1.6 keV T e = 1.6 keV, T i = 550 eV
16
Embed
Simulation of Stimulated Brillouin Scattering and ...
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
C. RenUniversity of RochesterLaboratory for Laser Energetics
46th Annual Anomalous Absorption Conference
Old Saybrook, CT1–6 May 2016
Simulation of Stimulated Brillouin Scattering and Stimulated Raman Scattering in Shock Ignition
1
Transmitted laser intensity at n = 0.17 nc (from HLIP)
11.0
1.5
2.0
2.5
3.0
3.5
5 9
Incident intensity (×1015 W/cm2)
Tran
smitt
ed in
ten
sity
(×
1015
W/c
m2 )
13 17 21
Te = 3.5 keV, Ti = 1.6 keVTe = 1.6 keV, Ti = 550 eV
Laser–plasma instabilities below the quarter-critical surface are important in shock ignition
Summary
TC12764
• Particle-in-cell (PIC) and fluid simulations find that stimulated Brillouin scattering (SBS) and stimulated Raman scattering (SRS) in the low-density region can cause significant pump depletion of the ignition pulse in shock ignition
• SBS is reduced by the plasma flow
• New simulations with both realistic seed levels and nonlinear physics are needed
2
Collaborators
L. Hao, J. Li, W.-D. Liu, and R. Yan
University of RochesterLaboratory for Laser Energetics
We thank the UCLA-IST Consortium for the use of the particle-in-cell code OSIRIS*
The 40 + 20 spherical shock-ignition experiment on OMEGA used separate compression and ignition beams
TC12736
• 60 OMEGA beams were split into 40 low-intensity drive beams (~14 kJ) and 20 tightly focused, delayed beams (~5 kJ)
Target design and laser pulse shape*
*W. Theobald et al., Phys. Plasmas 19, 102706 (2012).
0.1
0.2
0.3
0.4
0.5
0.01 2 3 4
Variable delay
40 drivebeams
20 “spike” beams,tight focus
0
Bea
m p
ow
er (
TW
)
Time (ns)
CH
390 nm
34 nm
0.1 nm Al
25 atmD2 gas
4
Simulation parameters similar to the 40 + 20-beam shock-ignition (SI) experiments on OMEGA*
TC12737
• Ln = 170 nm
• Ux/c = 4.26 × 10–6 x (nm) – 0.00356
• Two temperatures:
Te/Ti = 3.5 keV/1.6 keV = 2.2 (HT)
Te/Ti = 1.6 keV/0.55 keV = 2.9 (LT)
• I = (2 to 20) × 1015 W/cm2
HT: high temperature LT: low temperature * W. Theobald, et al., Phys. Plasmas 19, 102706 (2012). ** R. Yan, J. Li, and C. Ren, Phys. Plasmas 21, 062705 (2014).
Typical plasma profile in shock ignition**
00.0
0.1
0.2
0.3
0.4
200 400
Plasma profile
ne
(nc)
ux
(×10
–3 c
)
x (nm)600 800
–4
–3
–2
–1
0neux
5
6
Ion-density fluctuation
4
GEx H2 GEx H[×10–4(mec~0/c)2]
2
1.51.0
0.5
1.5
1.0
0.5
0.000
0.004
0.008
dn (nc)
2
6
–0.05
0 to
5
5 to
10
10 to
25
25 to
50
50 to
100
100
to 1
50
150
to 2
00
200
to 2
50
250
to 3
00
0.00
0.05
0.10
0.15CollisionlessCollisional
4
2
200x (c/~0)
(keV)
400 600
200x (c/~0)
400 600 200x (c/~0)
400 600t
(ps)
t (p
s)
En
ergy
flu
x (i
np
ut
lase
r flu
x)
In a conventional inertial confinement fusion (ICF) scheme, laser–plasma interactions (LPI’s) at nc/4 reach a steady state
TC12738
• I = 6 × 1014 W/cm2 L = 150 nm Te = 3 keV Ti = 1.5 keV n = 0.21 to 0.27 nc
• Hot electrons are staged, accelerated from left to right
• Collisions can reduce hot electrons
R. Yan et al., Phys. Rev. Lett. 108, 175002 (2012).
6
Interplay of the modes at different densities leads to intermittent LPI activities at SI intensities
TC12739
• I = 2 × 1015 W/cm2 L = 170 nm n = 0.17 to 0.33 nc
– low T: Te = 1.6 keV Ti = 0.55 keV
– high T: Te = 3.5 keV Ti = 1.6 keV
• Significant pump depletion is seen at nc/4
R. Yan, et al., Phys. Plasma 21, 062705 (2014).
GEx H in x–t2
Low T
8
0.0000
0.0001
0.0002
0.0003
0.0004
6
4
2
0
20t (p
s)
15
10
5
00 500 1000 1500
High T
(mec~0/e)2
x(c/~0)
0.0000
0.0001
0.0002
0.0003
0.0004
7
A single Maxwellian fit Thot = 29.5 keV was consistent with the experimental values Thot = 30 to 40 keV
Fluid simulations with HLIP see smaller reflectivities
TC12746 *L. Hao et al., Phys. Plasmas 21, 072705 (2014).
0.0
0.4
0.8
2 × 1015 W/cm2
5 × 1015 W/cm2
No
rmal
ized
inte
nsi
ty
HT LT
PumpSRSSBS
0
0.0
0.4
0.8
200 400x (nm)
600 800 0 200 400x (nm)
600 800
12
Compared to HLIP, OSIRIS has kinetic and nonlinear physics but also higher seed levels for convective SRS and SBS
TC12747
• High seed levels can lead to high saturation levels for convective modes
• HLIP lacks nonlinear physics such as density-modulation–induced absolute SRS*
–12
0 200 400
x (nm)
No
rmal
ized
see
ds
of
scat
tere
d li
gh
t (l
og
10)
600 800
–10
–8HT
LT
–6
–4
–2
–12
–10
–8
–6
–4
–2
SBS seeds in HLIPSRS seeds in HLIPFitted SBS seeds in PICFitted SRS seeds in PIC
13
*J. Li, this conference.
Laser transmittance may be limited by LPI
TC12748
Transmitted laser intensity at n = 0.17 nc (from HLIP)
11.0
1.5
2.0
2.5
3.0
3.5
5 9
Incident intensity (×1015 W/cm2)
Tran
smitt
ed in
ten
sity
(×
1015
W/c
m2 )
13 17 21
Te = 3.5 keV, Ti = 1.6 keVTe = 1.6 keV, Ti = 550 eV
14
Open questions
TC12750
• Modeling of LPI coupling in the entire coronal region
– computation challenge (1020 FLOPS in 2-D)
– seed levels for convective modes
• Coupling LPI and hydro simulations
• Integrated design for ICF
FLOPS: floating-point operations per second
15
TC12764
16
Summary/Conclusions
Laser–plasma instabilities below the quarter-critical surface are important in shock ignition
• Particle-in-cell (PIC) and fluid simulations find that stimulated Brillouin scattering (SBS) and stimulated Raman scattering (SRS) in the low-density region can cause significant pump depletion of the ignition pulse in shock ignition
• SBS is reduced by the plasma flow
• New simulations with both realistic seed levels and nonlinear physics are needed