Shaft Mounted Gearbox FLOW & INDUSTRIAL www.hmagrp.com Email: fl[email protected]POULIBLOC 2000 The Poulibloc 2000 or PB range of gear boxes are arguably the best shaft mounted gearbox available in Australia today. The flexibility of the unique taper bush mounting system makes the gear box the most versatile for use in Australian quarries. The ability to re machine the Poulibloc mounting bush means that it can be matched to any head drum shaft whether it be metric or imperial negating the need to change the drum shaft or the use of clumsy adaptor reduction bushes often resulting in the need to use oversized gear boxes. Poulibloc’s unique mounting bush system where with the use of a “C” spanner (supplied with every gear box) not only allows the gearbox to be drawn onto the shaft and clamped but also acts as a press tool to remove the gearbox eliminating the need cut off drum shafts. 15860 8530 5580 3200 2830 1410 910 630 0 5000 10000 15000 20000 27 26 25 24 23 22 21 20 Torque Nm Size Maximum Output Torque
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
The Poulibloc 2000 or PB range of gear boxes are arguably the best shaft mounted gearbox available in Australia today. The flexibility of the unique taper bush mounting system makes the gear box the most versatile for use in Australian quarries. The ability to re machine the Poulibloc mounting bush means that it can be matched to any head drum shaft whether it be metric or imperial negating the need to change the drum shaft or the use of clumsy adaptor reduction bushes often resulting in the need to use oversized gear boxes. Poulibloc’s unique mounting bush system where with the use of a “C” spanner (supplied with every gear box) not only allows the gearbox to be drawn onto the shaft and clamped but also acts as a press tool to remove the gearbox eliminating the need cut off drum shafts.
◊ : Small bore, as per GA shown ◊◊ : Large bore, Key supplied - not shownFor fitting of the bush, refer to commissioning instructions (installation manual).
Minimum length of customer’s shaft
Customer shaft small bore Customer shaft large bore
Torque Arm
Torque Arm must be located to the centre of the bracket.3 positions possible (Pb27 : 2 positions).