Setting up, Care and Maintenance of the Promethean Board Jan. 7 & 8, 2010 Presenter: Lilian L. E. Ventura, M.L.I.S. Librarian, St. Croix Central High School http://www.stx.k12.vi
Jan 18, 2016
Setting up, Care and Maintenanceof the Promethean Board
Jan. 7 & 8, 2010Presenter:
Lilian L. E. Ventura, M.L.I.S.Librarian, St. Croix Central High School
http://[email protected]
The Interactive Board
• Advisable to be left plugged on (even during holidays and summer)
• In case a permanent marker was used—– NO ABRASIVES, NO CHEMICALS – use Magic eraser
by Mr. Clean or use the permanent marker itself
• Clean with soft cloth, damped with light soap and water
The projector
• Must have a steady red light
• To turn off- click the red buttonon the remote TWICE
NOTE: There is nothing you can do until the BLINKING RED light stops
Setting Up• It is advisable to plug in all cables first before
turning on anything
• Turn on your laptop or computer first before the projector
1. The projector cable - (blue or black one)
2. The board cable – (off white – fr. board to the USB port)
3. The speaker cable – (black with red and white ends)
Setting Up
• It is advisable to plug in all cables first before turning on anything
1. The projector cable - (blue or black one)
Setting Up3. The speaker cable – (black with red and white ends)
The remote controlOn / Off
Key stone
Freeze button
No show
Use:
Key stone – to adjust theHeight and width of theScreen
Freeze – to keep a chartFrozen on the boardWhile you work onAnother
No show – to keep theProjector on but showingNothing at all (advisableFor saving the time toPower up orWarm up)
The pen
• Hold the pen by the orange band• The orange button is for right click• The nib is detachable / replaceable
To Calibrate:1.Hover the pen on the flame at the left upper corner of the board
Or2. At dashboard > configure> calibrate
Design Mode
• If you accidentally get into DESIGN MODE,– Uncheck the design mode at the Menu folder
• To open and save a new flipchart– Go to Main menu > flipchart > save to > My
flipcharts
•To customize your tool box:Main menu > customize > Toolstore> drag in / out
To Delete or undo
• Use spray tool - deleted annotations (any texts , writings, or objects on TOP LAYER)
• Select and click trash can• Select and drag to the trash can• Click UNDO arrow• Use ERASER (does not really erase but
covers Up; can only erase TOP LAYER)