Setting up ADSL2MUE 2.18-AU firmware for Bridge Mode Rhod Brown Systems Engineer Cisco-Linksys ANZ Preface A small number of ADSL2MUEs shipped in Australia and New Zealand with a non standard Linksys interface. An alternate version of firmware providing the standard Linksys interface will be available from the www.linksys.com.au site at: http://www.linksys.com/international/firmware.asp?intfwid=68&coid=19 Please note the current version of firmware there (1.00.6) is an older version of code, the correct version should be posted by Tuesday 7/6/05. For those users who are waiting on that code, this document demonstrates how to configure the ADSL2MUE with the non standard interface (2.18-AU) in Bridge Mode. Step 1 Power on the ADSL2MUE, and connect your PC into the yellow port labeled “Ethernet” on the back of the ADSL2MUE. Please ensure that your network card is set to DHCP before you do this, as the ADSL2MUE has an inbuilt DHCP server which is enabled by default, and will assign an IP Address to your PC. Step 2 You can confirm your PC has been assigned an IP Address by going to Start->Run and typing “cmd” – this will bring up a command window. At the prompt below type in “ipconfig” and hit Enter – you should see output as per below:
16
Embed
Setting up ADSL2MUE 2.18-AU firmware for Bridge Modeforum.linksys.free.fr/Produits_Linksys/ADSL2MUE/Manuel d...Setting up ADSL2MUE 2.18-AU firmware for Bridge Mode Rhod Brown Systems
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Setting up ADSL2MUE 2.18-AU firmware for Bridge Mode
Rhod Brown
Systems Engineer
Cisco-Linksys ANZ
Preface
A small number of ADSL2MUEs shipped in Australia and New Zealand with a
non standard Linksys interface. An alternate version of firmware providing the standard
Linksys interface will be available from the www.linksys.com.au site at: