Setting up a go kart the first time

Setting up a Go Kart the First Time

www.cvtclutch.com

Assembling a go kart for the first can be tricky especially if you are not prepared and

you lack knowledge in setting it up.

Most beginners prefer do-it-yourself go kart setting up

but the problem for some racers is that they tend to do the nitty-gritty setup task a week before the

racing season.

When this happens, it’s time to follow these easy steps and make sure that you

have all the tools needed.

Here are some of the tools that you will need:

• Metric Hex Wrench Set• Ratchet Set• Needle Nose Pliers• Assorted Wrenches• Nuts, Bolts and Washers

in different sizes

When it comes to go kart parts, here are what you will

need:

• Safety wire• Fuel line• Go kart grade chain• Throttle cable• Go kart seat• Cable ties

• Chain guard• Motor mounts• Tachometer• Motor mounts• Go kart body kit• Fuel tank• Rear sprockets

The first thing to do in setting up your go kart is to

start with mounting your seat.

Mounting the seat is the hardest task of the entire

installation.

Thus most kart experts recommend that it will be

done by setting the kart up on the ground without rims such that the chassis rests

on the ground.

After the seat is successfully mounted, the next thing to do is to mount the engine.

Before the actual mounting, be sure that you have your

clutch and sprocket installed in the engine.

When done, you can simply setup the engine and you

are ready to go.

When all seems to be in their respective places, you can now make a permanent

adjustment to the engine until the chain achieves its

proper tightness.

For a huge collection of go kart clutch,

check out cvtclutch.com.

We offer top quality go kart clutches that will fit

your needs.

High performance gokart clutch will make a

difference in your race.