MATERIAL SAFETY DATA SHEET MAY BE USED TO COMPLY WITH OSHA'S HAZARD COMMUNICATION STANDARD 29CRF 1910.1200 DATE PREPARED: 8/19/08 SIGNATURE OF PREPARER (OPTIONAL) SECTION 1 CHEMICAL PRODUCT / NAME Product/Chemical Name: CTG Product No: CAS Number: Other Designations: General Use: SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS R E H T O H I G C A A H S O U E Ingredient Name: S T I M I L V L T ) A W T ( L E P R E B M U N Toner is regulated under OSHA as particulate not otherwise regulated: d e t s i l t o n d e t s i l t o n 0 6 - 0 4 r e m y l o p o C e t a l y r c A - e n e r y t S 3 m / g m 5 3 m / g m 0 1 5 5 - 5 3 e d i x O n o r I d e t s i l t o n d e t s i l t o n 5 < x e l p m o c c i l l a t e m o n a g r O 3 m / g m 0 1 3 m / g m 2 O i S % / 0 8 5 < a c i l i S s u o h p r o m A NDA = NO DATA AVAILABLE N/A = NOT APPLICABLE SECTION 3 HAZARDOUS IDENTIFICATION Primary Entry Routes: Target Organs: HEALTH 1 Acute Effects: FLAMMABIL 1 Inhalation: REACTIVITY 1 Eye: PPE (Sec.8) - Skin: Ingestion: Carcinogenicity: Medical Conditions Aggravated By Long-Term Exposure: Chronic Effects: SECTION 4 FIRST AID MEASURES Inhalation: Eye Contact: Skin Contact: Ingestion: Special Precautions / Procedures: SEB0263R Clean mouth with water. Drink several glasses of water. N/A Remove to fresh air. Treat any irritation symptomatically. Call a physician if condition persists. In case of contact immediately flush with plenty of low pressure water for at least 15 minutes. Remove any contact lenses to ensure thorough flushing. Seek medical advice. Wash well with soap and running water. Slight irritation. If these materials are used in a manner that could generate airborne particles (dust), it is recommended that After first aid, get appropriate in-plant paramedic or community medical support if serious signs and symptoms persist. Note to Physicians: N/A the dust may be treated as a NUISANCE PARTICULATE according to the American Conference of Government Industrial Hygienists (ACGIH)(TLV=10mg/m 3 ). Ingestion is unlikely route of entry under normal conditions of use. N/A may cause congestion. Accumulation of dust in the respiratory system N/A N/A Slight irritation of respiratory tract may occur with exposure to large amount of toner dust. Dust may cause irritation by mechanical abrasion. % NFPA/HMIS Canon 104 Toner Laser Printer N/A Mixture Inhalation CAS NUMBER 25767-47-9 12227-89-3 Distributor: Staples Inc. 500 Staples Drive Framingham, MA 01702 Manufacturer/Supplier Name: Clover Technologies Group i
4
Embed
SECTION 1 CHEMICAL PRODUCT / NAME Canon 104 Toner D is t ... · D is t rbu o : Staples Inc. 500 Staples Drive Framingham, MA 01702 Manufacturer/Supplier Name: Clover Technologies
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
MATERIAL SAFETY DATA SHEETMAY BE USED TO COMPLY WITH OSHA'S
HAZARD COMMUNICATION STANDARD
29CRF 1910.1200
DATE PREPARED: 8/19/08 SIGNATURE OF PREPARER (OPTIONAL)
SECTION 1 CHEMICAL PRODUCT / NAMEProduct/Chemical Name:
CTG Product No:
CAS Number:
Other Designations:
General Use:
SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTSREHTOHIGCAAHSOUE
a MSHA/NIOSH-approved respirator. Select respirator based on its suitability
to provide adequate worker protection for given working conditions, level of
airborne contamination, and presence of sufficient oxygen. For emergency or
nonroutine operation (cleaning spills, reactor vessels, or storage tanks), wearan SCBA. Warning! Air-purified respirators do not protect workers in oxygen-deficient
atmospheres.
Protective Clothing/Equipment: Wear chemically protective gloves, boots, aprons, and gauntlets to prevent
prolonged or repeated skin contact. Wear protective eyeglasses or
chemical safety goggles, per OSHA eye and face protection regulations
(29CFR 1910.133). Contact lenses are not eye protective devices. Appropriate
protection must be worn instead of, or in conjunction with contact lenses.
Safety Stations: Make emergency eyewash stations and washing facilities available in work area.
Contaminated Equipment: Separate contaminated work clothing from street clothes. Launder before
re-use. Remove this material from your shoes and clean personal protective
equipment.
Comments: Never eat, drink, or smoke in works areas. Practice good personal hygiene after using this
material, especially before eating, drinking, using the toilet, or applying cosmetics.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES:ytilibuloS retaW:etatS lacisyhP Negligible
Appearance and Odor: Black, free flowing powder, odorless Other Solubilities: Partially soluble in toluene & tetrahydrofuran
Odor Threshold: N/A Boiling Point: N/A
Vapor Pressure: N/A Freezing/Melting Point: N/A
Vapor Density (Air=1): Heavier than air. Viscosity: N/A
Formula Weight: N/A Refractive Index: N/A
Density: N/A Surface Tension: N/A
Specific Gravity: (H2O)=1, at 4°C): 1.5-2.5 % Volatile: N/A
pH: N/A Evaporation Rate: N/A
SECTION 10 STABILITY AND REACTIVITYStability: Stable
Polymerization: Will not occur
Chemical Incompatibilities: None
Conditions to Avoid: No Data
Hazardous Decomposition Products: Only after combustion
SECTION 11 TOXICOLOGICAL INFORMATION
Eye Effects: N/A Toxicity Data:*
Skin Effects: N/A Acute Inhalation Effects: N/A
Acute Oral Effects: N/A
Chronic Effects: N/A
Carcinogenicity: N/A
Mutagenicity: Ames Test (Estimated from the results of
Negative testing the constituent components)
Teratogenicity: N/A
*See NIOSH, RTECS for additional toxicity data.
SECTION 12 ECOLOGICAL INFORMATIONEcotoxicity: N/A
Environmental Fate: N/A
Environmental Degradation: N/A
Soil Absorption / Mobility: N/A
SECTION 13 DISPOSAL CONSIDERATIONSDisposal: Waste material may be incinerated / or recycled for its Iron Oxide under conditions which meet
all federal, state, and local environmental regulations.
Disposal Regulatory Requirements: N/A
Container Cleaning and Disposal: N/A
SECTION 14 TRANSPORT INFORMATIONDOT Transportation Data (49 CFR 172.101): Not specifically listed.