October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford LEAD SPLICE SPECIFICATION BY: ROY HANNAFORD
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
LEAD SPLICE SPECIFICATION
BY: ROY HANNAFORD
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
SOLDER BOX MOUNTING PLATE 7500 AMP.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
ROUTING AND BEND RADIUS FOR CABLE.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Layout with four cables in solder box.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Assemble cables and
solder in box.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Place aluminum push block over the top
piece of conductor.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Install top plate to
hold tension while
soldering.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Insert cartridge
heater and heat joint to 240 C and
tighten clamp bolts.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
7500 Amp HTS Lead
Clean joint install
voltage taps and insulate
cables.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Remove Kapton
insulation and prep joint for
soldering.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Tin wire and insert into solder
fixture.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Assemble wire and lead into
solder fixture.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Install solder
fixture top plate.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Insert cartridge
heater and heat joint to
240 C, tighten
screws on fixture.
October 23-24, 2002 RFP Review DFBX Feedbox Roy Hannaford
600 /120 Amp Lead
Clean joint install
voltage taps and insulate
wire.