Ron Gray - Peter Miller’s Peggy Sue 2, build 3 Today’s target was to get the fuselage sides joined together. First of all I had to cut out the cabin window surrounds from 1/32nd ply (my fingers hurt!) then I reprinted one of the formers as I had used black filament on the first one and if I use a transparent film for the fuselage then black would be a bit harsh. So I printed it again this time in grey but I also hollowed out the former to save a bit of weight. I decided to use my magnetic building board for this step as it allows easy adjustment to make sure things are square. First side with the formers attached. Peggy Sue 2, build 3 Ron Gray Page of 1 6