Replace Gas Valve - Nexgrill Industries, Inc. | BBQ Gas Grills

Replace Gas Valve

1)Remove the 4 screws that hold the Emitter top to the Emitter base

2) Remove Emitter top with Reflector

Replace Gas Valve

3) Remove the screw of the gas collector box

4) Remove the bottom plate of the gas collector box

Replace Gas Valve

5) Pull outward to remove the control knob

6) Remove all screws from the control panel (3 on each side)

Replace Gas Valve

7)Take out the front control panel

8) Remove burner by turning it counter clockwise until loose

Replace Gas Valve

9) Take out the burner from the unit

10) Remove all screws that connect the controlhousing base to post

Replace Gas Valve

11) Remove the whole burner head assembly from the post

12) Remove the screw from the control front housing base

Replace Gas Valve

13) Remove all the screws from control housing base

14) Remove the 4 screws from the bottom of the control housing base

Replace Gas Valve

15) Remove pilot assembly from emitter base- remove the screw located on outside of emitter base.

16) By pilot nut located on inside fire pit of emitter base

Replace Gas Valve

17) Remove head housing from gas valve

18) Separate the gas valve from the head housing

Replace Gas Valve

19) Remove the pilot gas line by using an 12mm open wrench

20) Pilot gas line has been removed from the gas valve

Replace Gas Valve

21) Disconnect the 2 wires that go to the mercury switch

22) Remove the nut washer that holds the valve bracket

Replace Gas Valve

23) Remove gas line (hose) from gas valve by using¾” wrench

24) Remove gas valve from support bracket:- support bracket securely upside down- with an adjustable wrench counter clockwise to

remove the nut from valve feed intake

Replace Gas Valve

25) Separate the bracket from valve

To install it: reverse the procedure

*Warning: make sure all connections are secured& tight when install