-
8/6/2019 Replace Bulbs Corolla
1/3
DI Y write-up for instrument gauge cluster
The project was for my wife's '98 CE, and it was easier than I thought it would be. Lasted no more than 20 m inutes tops
The objective was to replace the burnt out 19 4 bulb that pr ovides the backlighting for the right part of t he speedometer. Here are the steps:
1) Locate and remove th e 2 Philips screws (circled in yellow) on t op of the gauge cluster plastic frame.
2) Pull the frame out grasping the top and bottom ends (you may need to use a screwdriver to gently pop out the sides). Don't worr y about the plasticmaterial of the frame; it 's fairly strong.
3) The instrum ent cluster should now look like in the pic below. Next, locate and rem ove 3 Philips screws (circled in yellow) from the actual cluster.
4) Lift t he cluster up and out of the dashboard, and unclip the 4 electrical connectors from the cluster.
This image has been resized. Click this bar to view t he full image.
This image has been resized. Click this bar to view t he full image.
This image has been resized. Click this bar to view t he full image.
Page1 of 3DIY write-up for instrument gauge cluster - Toyota Nation Forum : Toyota Car and Truck...
6/28/2011http://www.toyotanation.com/forum/showthread.php?p=2937631
-
8/6/2019 Replace Bulbs Corolla
2/3
5) To access the backlighting bulbs, locate the 3 green-colored sockets (circled in yellow) on t he back side of the cluster. Just twist to unlock, and pull out t he194 bulb attached to the socket. It 's th at easy
This image has been resized. Click this bar to view t he full image.
This image has been resized. Click this bar to view t he full image.
Page2 of 3DIY write-up for instrument gauge cluster - Toyota Nation Forum : Toyota Car and Truck...
6/28/2011http://www.toyotanation.com/forum/showthread.php?p=2937631
-
8/6/2019 Replace Bulbs Corolla
3/3
The pic below shows the burnt out bulb on th e far left, what the actual bulb looks like in the middle (wit h the green rubber cap), and a brand new 194LL clearbulb ($2.75 for a 2-pack from Wal-mart) . The green rubber cap must be saved for the new bulbs since that is how the green colored backlighting is obtained.Of course you can put in a different color rubber cap (like blue or red) but my wife loves the stock green. You can find these rubber caps at your local autoparts or performance shop, or find a local dealer at http: // www.autom eter.com.
Hope this helps anyone out there with backlighting problems or issues
-Doug
This image has been resized. Click this bar to view t he full image.
Page3 of 3DIY write-up for instrument gauge cluster - Toyota Nation Forum : Toyota Car and Truck...
6/28/2011http://www toyotanation com/forum/showthread php?p=2937631
