Priming Information When using your RecoveryWrap System it is important to PRIME This can be done by operating the RecoveryWrap System with the new pad attached for at least 3 min set to 1. Press the Power Switch to the ON “ ” position. 2. Prime the unit: Adjust the Temperature Control Knob to a comfortable setting. to continue. RecoveryWrap System Instructions for Use Please read these instructions completely and carefully before applying this product. Correct application is important for proper function. Control Unit Pad Tubing Set Setting up the system is a simple three-step process. (1) The user with ice and water, (2) then applies the RecoveryWrap Pad with an insulation barrier between the pad and skin, around the attaches the control unit to the pad via the tubing set. Warning NNO part of the pad should directly touch the skin. Once the control unit is turned on, cold water is passed through then circulated through the pad, drawing heat from the body through the tubing set to the control unit where it is re-cooled and then re-circulated back to the pad. When using this system, please check the skin where the pad is applied periodically. Discontinue use if continued numbness, skin discoloration, blisters, etc. are present. Please refer to your health care professional prior to applying this system and/or using the system for extended periods of time. Warning NO part of the pad should directly touch the skin. Patient Discharge Instructions 1. Assess Patient: Screen the patient for any contraindications and/or associated risk factors. If the patient has any contrain- dications, do NOT dispense the RecoveryWrap System for treat- ment. Consult a healthcare practitioner regarding the use of the RecoveryWrap System. 2. Quick Guide: Refer to the quick guide for setup and directions to apply the pad correctly. Instruct the patient on how to properly use the RecoveryWrap System. 3. Protocol: Instruct the patient on the prescribed healthcare practi tioner protocol (frequency and duration of use). Instruct patient on periodic assesment of the skin area and the treatment period. 4. Potential for Injury: Instruct patient that improper use can result in serious inury. Emphasize proper use, pad placement, skin inspection, and following the prescribed protocol. 5. Pad Application: DO NOT apply the RecoveryWrap Pad direct- ly to the skin. There should be a wound dressing or insulating material between the skin and the pad. NO part of the pad should directly touch the skin. 6. Skin Inspection: Instruct the patient to visually inspect the skin per the healthcare practitioners instructions, typically every 1 to 2 hours. 7. Discontinue use of the RecoveryWrap System if you experience any adverse reactions such as: burning, increased pain, increas- ed swelling, increased redness, discoloration, itching, welts, blis- ters or any other changes to the skin appearance or condition. Contact your healthcare practitioner immediately. Indications and Contraindications General Indications for Cold Therapy There are general indications for using cold therapy across the body and in various situations: • First aid after trauma • Relief of pain • Prevention or reduction of swelling of traumatic origin Cold is preferred during treatment of acute injury, sub-acute Contraindications for Cold Therapy Users should be aware of situations where cold therapy may - wise contraindicated for use. • Cold Uticaria • Cryoglobulinemia • Raynaud’s Syndrome • Proximal cold hemoglobinuria • Vasospastic disease • Cold hypersensitivity • Peripheral neuropathy (as in some cases in diabetes) • Compromised local circulation Users should take caution in applying cold therapy over open sores and abrasions. At a minimum these areas should be cleaned and bandaged. Directions For Use: 1. Unlock and remove lid by rotating handle away from the vertical position. 1 2 3 OFF ON OFF ON switch OFF ON 40˚F 70˚F 5. Replace lid onto the unit- make sure to line up the cutout with the notch on the lid. 6. Lock lid onto the unit by returning the handle to the vertical position. 7. Connect BLUE connector hose to the unit by aligning the white dots and pressing into the slot. 8. Connect BLUE connector hose (opposite end) to the cold therapy pad by aligning the white dots and pressing together. 9. Attach the power cord to the unit. 10. Turn unit on with the green button on the top of the lid. 11. Adjust temp control knob to the image showing 3 12. Allow unit to PRIME for 3 minutes- additional ICE/WATER may need to be added after this process – Turn unit OFF before removing the lid to add ICE/WATER to the unit. 13. Over a dressing or moisture barrier apply the pad to the directly to the skin. 14. Adjust the temp knob based on physician recommendation. pad. Patient Use Tips 1. Use cubed ice for best performance. 2. You may disconnect the RecoveryWrap pad from the unit blue tabs on the hose coupling and gently pulling the hose from the connector. The pad will seal itself and will not leak. 3. Do NOT run the unit without water in the container. The pump is designed to run WITH water. Unplug the unit before removing the lid from the water container.