QuickShifter easy Supplementary Manual Suzuki GSX1300R Hayabusa 1999-2007 (iQSE-1 + QSX-P4B) www.healtech-electronics.com 1/3 Remove the main seat. Lift up or remove the fuel tank. Remove the airbox.
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
QuickShifter easySupplementary Manual
Suzuki GSX1300R Hayabusa 1999-2007 (iQSE-1 + QSX-P4B)
w w w . h e a l t e c h - e l e c t r o n i c s . c o m 1/3
Remove the main seat.
Lift up or remove the fuel tank.
Remove the airbox.
QuickShifter easySupplementary Manual
Suzuki GSX1300R Hayabusa 1999-2007 (iQSE-1 + QSX-P4B)
w w w . h e a l t e c h - e l e c t r o n i c s . c o m 2/3
Plug the QSX connectors in-line with the ignition coil connectors.
(Black, 2-pole connectors below the airbox)
Mount the QSX module to the inner side of the frame by the supplied Velcro strips, and secure the cables with cable ties.
(Avoid direct contact with heat sources, like the cylinder head.)
Connect the QSX Black wire terminal to the chassis ground.
QuickShifter easySupplementary Manual
Suzuki GSX1300R Hayabusa 1999-2007 (iQSE-1 + QSX-P4B)
w w w . h e a l t e c h - e l e c t r o n i c s . c o m 3/3
Mount the QSE sensor.
(Place the sensor in the rod as shown. Use the washers supplied at both sides of the sensor. Tighten the nut by hand fully and then by a 1/4 turn using a wrench but maximum to about 6 Nm.)
Typical position for the QuickShifter easy. Secure the unit properly.
Related Documents
