1/2 TURN TO STOP Installation of Electronic Cover Plate ► 9/16 Open-end wrench (for Redtail) ► 1/2 Open-end wrench (for Roadside) Installation onto Gauge Head ► 7 / 16 Open End Wrench Calibration (Zero & Span) ► Connections to you PLC or a Fluke 780 (or Eq.) 24 VDC Loop Calibrator ► 1/8” Blade screwdriver This document contains the recommended basic procedures installing and calibrating the Hawkeye Industries Goshawk Level Transmitter for use on a Redtail or Roadside Gauge Head. For more comprehensive instructions, please refer to the Goshawk Operation and Trou- bleshooing Guide. Requirements The gauge board, indicator, float, and gauge head, shall be in place per their respective installation instructions prior to Goshawk installation. Tools Parts Required Goshawk Installation on Gauge Head TANK PREPARATION | GAUGE BOARD KIT INSTALLATION | FLOAT GUIDE KIT INSTALLATION | GAUGE HEAD INSTALLATION | GOSHAWK INSTALLATION Quick Start Installation Instructions Goshawk Level Transmitter QTY Part ► 1 Goshawk Level Transmitter ► 2 1/4-20 UNC x 3/4 Hex Cap screw (included) Installation on Redtail ► 1 Redtail Gauge Head with ► 1 Redtail Electronic Cover Plate installed Installation on Roadside ► 1 Roadside Gauge Head with: ► 1 Roadside Electronic Cover Plate installed 1 2 3 4 If the electronic cover plate is not already installed, remove the standard cover plate from the Indicator (Open) side of the gauge head, and replace with the appropriate Electronic Cover Plate for your gauge head. Turn the indicator cable spool IN THE EMPTYING DIRECTION (CLOCK- WISE) until the the indicator is in the empty position (top of gauge board). Immobilize the spool. (cover omitted for clarity) Goshawk Quick Installation Instructions, March 2014. Replaces May 2012 document 1 Turn the Transition Coupler on the Goshawk Transmitter IN THE EMPTY- ING DIRECTION (COUNTER-CLOCKWISE) until it stops. DO NOT OVER TURN, AS DAMAGE WILL OCCUR. Then turn the Transition Coupler on the Goshawk Transmitter IN THE FILLING DIRECTION (CLOCKWISE) one-half turn Aligning the tangs on the transmitter with the cover plate bolt holes and fasten with the 1/4 NC Hex Cap Screws. Ensure the transition coupler mates with the gauge head axle without binding by turning the reel a few times before tightly securing the transmitter to the cover plate. REDTAIL ROADSIDE REDTAIL ROADSIDE