Quick guide for Implantmed SI-1010 / SI-1015 / SI-1023 Hygiene and maintenance – Motor with cable Start-up – General Connect the mains cable and foot control. Connect motor cable. Insert the irrigant support. Attach the universal support and lock it. Open the pump cover. Insert the irrigation tubing. Close the pump cover. Plug the mains cable into a earthed power socket. Switch on the control unit at the power switch. Control unit operation – Main menu 16 max. 50 Ncm 1:1 rpm 40 000 Implantology 1 My favorites Set program Documentation (DOCU) Set speed / torque Setup Progress display mode Forward/reverse operation mode Programs 1 to 5 Set coolant volume Pre-disinfection > If heavily soiled, clean first with disinfectant cloths. Motor with cable Do not twist or kink the motor cable! Do not coil it too tightly! Manual cleaning > Rinse and brush off with demineralized water (< 38°C) Mechanical cleaning and disinfection > Use only thermo washer disinfectors with a drying program for preparation. Sterilization W&H recommends sterilization according to EN 13060, class B. Other sterilization methods may reduce the life span of the motor. storage > Store sterile goods dust-free and dry. S-N2 S-NW