QNET DC motor control trainer

QNET DC Motor Control Trainer

By FADZLI & ZOUBAIR

SPEED CONTROL

POSITION CONTROL3

1

2

MODELING

•AGENDA

Stage 1• Lab 1: Bump Test

Stage 2• Lab 2: Model Validation

Stage 3• Results

What is modeling?

Modeling is Used in many places in industry to ensurethat a part has been produced within allowable tolerances

•MODELING

•MODELING: Bump Test

Lab 2: Model Validation

Same step with bump test

Difference is put the value of

K and t

Need to match the stimulation and the actual

system

•MODELING: Model Validation

Stage 1• Lab 1: Qualitative PI

Control

Stage 2• Lab 2: PI Control

According to Specifications

Stage 3• Lab 3: Set-Point Weight

Stage 4• Results

What is Speed control?

PID control is used in a wide array of industries.Speed control is used extensively in transportation and electronics.

•SPEED CONTROL

More About Speed Control Experiment

Is controlled using a proportional – integral control system

The speed control and position control are used to demonstrate the capabilities of a control system.

•MODELING: Bump Test

•MODELING: Model Validation

Stage 1• Lab 1: Bump Test

Stage 2• Lab 2: Model Validation

Stage 3• Results

What is modeling?

Modeling is Used in many places in industry to ensurethat a part has been produced within allowable tolerances

•MODELING

•MODELING: Bump Test

•MODELING: Model Validation

•SUMMARY

motion control feedback systems PID Modeling Speed control Position control

Concepts learned in the DC motor Control Trainer

Thank YouTHANK YOU