Thermal Insulation Products - Tapes, Foils & PIB Sealumet (Australia) Pty Limited Mailing Address : PO Box 2218, Warwick, Perth, WA, 6024 Warehouse : Unit 2, 6 Langar Way, Landsdale, Perth, WA - 6065 Telephone : +618 6201 6153, Fax : +618 9303 4560 E-mail: [email protected] Website: www.sealumet.com DISCLAIMER These data sheets are based on specifications, data and test results at time of publication. No guarantee as to completeness, accuracy or results is either expressed or implied. The suitability for an intended use is the responsibility of the user. As choice of material, method of application and site conditions are beyond our control we accept no liability for direct or consequential damages. Any material proved to be defective within the published shelf life* will be replaced. *From date of supply. Description PVC Electrical Insulation Tape, flame retardant / self- extinguishing. Offers good conformability. Colours - Black, White, Grey, Red, Green, Blue, Yellow, Brown, Orange, Violet, Yellow/Green, Service Green, Light Thermal Grey. Applications Wire and cable insulation, colour coding of electrical cables, loom harnessing, stopping off in plating, prevention of electrolytic corrosion, packaging applications, drum or tube sealing. Specification Certification to the following standards may be available on request. BS3924 31/907p. BS4J10. BS3887:IEC 454-3-I and AS1621. Note: Except where indicated otherwise the above figures are average values and should not be regarded as the MAXIMUM or MINIMUM values for any specification purposes. The company reserves the right to improve products and any change in the specification will result in a re-issue of the relevant ‘Technical Data’ sheet. Customers should satisfy themselves that the tape is suitable for their requirements, whether after such modifications or otherwise. Please check that you have the latest copy of the ‘Technical Data’ sheet. All slitting and length tolerances are to British Standards, but other tolerances are available on request. Before use the customer is advised to consult the Health & Data sheet produced by the company for this product, which is available on request. Technical Details PVC Electrical Insulation Tape Typical Values Thickness 0.145mm Breaking Load 26 N/cm Elongation 180% Adhesion -Steel 2.6N/cm -Self 2.1N/cm Water extract pH 6.8 Conductivity Max. 2mS/m Electrical Properties B/down Voltage 8.0 kV I Min proof test 6.0 kV Insulation Resist 10 mega ohms Cu Corrosion No staining Flame Retardancy Self extinguishing. Service Temp -5 deg C to 70 deg C Application Temp 0 deg C to 40 deg C Storage Temp 12 deg C to 25 deg C Storage Tapes stored below the minimum application temperature will require warning up to that level before use. Up to 24 hours may be required for this to take place. SL0072