Prof. Steven S. Saliterman Introductory Medical Device Prototyping Department of Biomedical Engineering, University of Minnesota http://saliterman.umn.edu/
Prof. Steven S. Saliterman Introductory Medical Device Prototyping
Department of Biomedical Engineering, University of Minnesota http://saliterman.umn.edu/
Prof. Steven S. Saliterman
• Launch SolidWorks • Select Resources to
open the Task Pane. • Select Tutorials
Prof. Steven S. Saliterman
Open Lofts
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Triad
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Prof. Steven S. Saliterman
Topics Covered in this exercise: ◦ Creating parallel planes. ◦ Sketching on specific planes and copying from one
plane to another. ◦ Lofted bose-base feature and connecting profiles. ◦ Flex feature, moving trim planes and bending
material
Slide Number 1Starting The TutorialsSelect Basic TechniquesHammer HeadCreating a Parallel PlaneAdding Two More PlanesSketch on Plane 2Circle Coincident with VerticesCopy-Paste Sketch from Plane 2 to 3Lofted Bose-Base FeatureSolid ModelCreating Plane 4Sketch on Plane 4Lofted Bose-Base Connected ProfilesFlex Feature and Trim PlanesMoving Material Between Trim PlanesFinished Hammer HeadSummary