PRODUCT DATASHEET Tyra series Ordering number Description Family Type LED Color Diameter Height Style Optic Material Holder Material Fastening Status C11394 C11394-Tyra-S Tyra Reflector MP-L Metal 40 mm 23.1 mm Round PC - Pin, glue Ready FWHM Efficiency cd/lm Gerber File 20 degrees - - Available Used with Tyco holder Ordering number Description Family Type LED Color Diameter Height Style Optic Material Holder Material Fastening Status C11395 C11395-Tyra-M Tyra Reflector MP-L Metal 40 mm 23.1 mm Round PC - Pin, glue Ready FWHM Efficiency cd/lm Gerber File 32 degrees - - Available Used with Tyco holder Ordering number Description Family Type LED Color Diameter Height Style Optic Material Holder Material Fastening Status C11396 C11396-Tyra-W Tyra Reflector MP-L Metal 40 mm 23.1 mm Round PC - Pin, glue Ready FWHM Efficiency cd/lm Gerber File 52 degrees - - Available Used with Tyco holder NOTE: The typical divergence will be changed by different color, chip size and chip position tolerance. The typical total divergence is the full angle measured where the luminous intensity is half of the peak value. November 22nd 2011 0:03 Copyright Ledil Oy - Subject to change without prior notice - Page 1/3 Ledil Oy Salorankatu 10 24240 SALO Finland http://www.ledil.com email: [email protected]FAX: +358-2-733 8001
4
Embed
PRODUCT DATASHEET Tyra series - Mouser ElectronicsC11395-Tyra-M Tyra Reflector MP-L Metal 40 mm 23.1 mm Round PC - Pin, glue Ready FWHM Efficiency cd/lm Gerber File 32 degrees - -
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
TyraReflectorMP-LMetal40 mm23.1 mmRound PC - Pin, glue Ready
FWHMEfficiencycd/lmGerber File
52 degrees - - Available
Used with Tyco holder
NOTE: The typical divergence will be changed by different color, chip size and chip positiontolerance. The typical total divergence is the full angle measured where the luminous intensityis half of the peak value.
November 22nd 2011 0:03 Copyright Ledil Oy - Subject to change without prior notice - Page 1/3
- Product series especially designed & optimized for MP-L series of LEDs. - Special care taken to make light distribution as uniform as possible.- Reflector is made of aluminium coated PC (120 degrees of Celcius / 248 degrees of Fahrenheit) withprotective lacquer (110 degrees of Celcius / 230 degrees of Fahrenheit).
- Fastening to PCB with appropriate adhesive. By clicking link below you can find Ledil recommended glueoptions.http://www.ledil.com/datasheets/DataSheet_GLUES.pdf
NOTE 1: We advise customer to ensure the suitability and sufficiency of the bond in the endproduct. For example, mechanical stress, vibration and holes on the surface of the circuit boarweaken the strength of the glue.
NOTE 2: All surfaces where glue is applied must be clean, dry and free from grease and dirt. Ifcleaning of PCB surfaces is needed, please follow strictly the cleaning instructions of your LEDmanufacturer -this is important as cleaning shall under no circumstances damage LEDs or otherelectronics components on the PCB.
Further note that optical components shall not be cleaned with any chemicals - only micro fibercloth may be used to remove fingerprints or other traces from handling.
November 22nd 2011 0:03 Copyright Ledil Oy - Subject to change without prior notice - Page 2/3