Presentation for carbon heating film installation. Dear Customers, the carbon heating film is a new and advance heating technology used for wooden and.

Presentation for carbon heating film installation.

Dear Customers, the carbon heating film is a new and advance heating technology used for wooden and

laminate floors. This presentation will show you how to install it.

Required materials not included in our package: heating insulation, thin PE film, laminate.

This is the installation which we used under the carbon heating film. It is sold in sheets so it is easy to arrange it on the floor. You can use any other kind of

floor heating insulation like cork, fibran etc.

Arranging the insulation on the floor. It is not necessary to use glue.

Arranging the insulation on the floor.

Arranging the insulation on the floor. If there is a lot of humid then a layer of nylon is applied first.

The carbon heating film is arranged on top of the insulation.

The sheets are arranged following a scheme which we make for your room dimensions and include in the

package. You don't need 100% coverage.

The sheets are arranged on the floor ready for installation.

All the cold ends are out.

In order to prepare this scheme we need you to send us a drawing of the room with all the dimensions.

The sheets are arranged on the floor ready for installation. All the cold ends are out.

After we arrange the carbon film on the floor we continue with the wiring.

The sheets are connected parallel. The power supply is

220-240V. All the connections are soldered and insulated.

The two cold ends of the system and the floor sensor cables go to the installation box /included in the package/. There you do the connection to the thermostat.

Use the aluminum tape in the package to glue the floor sensor on the heated part of the carbon heating

film /usually on the down side/.

Continue with the wiring.

Continue with the wiring.

Continue with the wiring.

The whole room is covered with the PE film .This is a very thin vapor material used for soundproofing and protective barrier between the carbon film and the

laminate.

Covering with the PE film.

Covering with the PE film.

Continue with the installation.

Continue with the installation.

Continue with the installation.

Continue with the installation.

You can see all the parts for the installation - heating insulation, carbon film, Pe film and then the laminate.

Here you can see a spot without a carbon film /under the PE film roll/ because a big cupboard will be there.

Continue with the installation.

Dear friends,I hope this presentation was useful.

For more information and any questions find us at www.vodoley91.com