ADP140564 TM Installation Instructions – Commercial Recessed Compact Fluorescent-Emergency Instructions d’installation - Ampoule fluorescente compacte encastrée d’urgence commerciale Instrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial INSTALLATION 1. To prevent electrical shock and unintentional battery discharge, do not join the unit connector until the installation is complete. Immediatly prior to premanently turning the A.C. Power on, engage the connector within the single gang switch box. SERVICING 1. This fixture provides more than one power supply output source. To reduce the risk of electrical shock, disconnect both normal and emergency sources by turning off the A.C branch circut and by disconnecting the connector on the charge indicator/test switch assembly. 2. The emergency source requires an unswitched A.C power source of either 120 or 277 volts. Properly cap the unused A.C. lead. Refer to wiring diagram. 3. This unit is for recessed ceiling mounting only. Do not use outdoors, in hazardous locations, nor near gas or electrical heaters. 4. This is a recessed ceiling mounted compact fluorescent unit, with standby battery operation. In the normal mode, lamp will be illuminated. In the emergency mode, one lamp will provide emergency illumination for a minimum of 90 min. In accordance with U/L standrad #924. The test switch and indicator light are provided for ceiling mounting near the fixture in a single gang switch box (provided). 5. When used in insulated ceilings, insulation must be kept off the unit and no closer than 3”from the unit on all sides. 6. Do not use this equipment for other than the intended use. 7. Install only in accordance with National Electrical Code and Local Regulatory Agencies requirements. 8. Installation and servicing to be performed only by qualified personnel. Standard Installation Figure 1. Figure 2. IMPORTANT: Read carefully before installing fixture. Retain for future reference. SAFETY: When Using Electrical Equipment, basic saftey precautions should always be followed, including The following:
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
INS #
Brand Logo reversed out of black
INS #697916 INS #ADP140564TM
Installation Instructions – Commercial Recessed Compact Fluorescent-EmergencyInstructions d’installation - Ampoule fluorescente compacte encastrée d’urgence commercialeInstrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial
INSTALLATION
1. To prevent electrical shock and unintentional battery discharge, do not join the unit connector until the installation is complete. Immediatly prior to premanently turning the A.C. Power on, engage the connector within the single gang switch box.
SERVICING
1. This fixture provides more than one power supply output source. To reduce the risk of electrical shock, disconnect both normal and emergency sources by turning off the A.C branch circut and by disconnecting the connector on the charge indicator/test switch assembly.
2. The emergency source requires an unswitched A.C power source of either 120 or 277 volts. Properly cap the unused A.C. lead. Refer to wiring diagram.
3. This unit is for recessed ceiling mounting only. Do not use outdoors, in hazardous locations, nor near gas or electrical heaters.
4. This is a recessed ceiling mounted compact fluorescent unit, with standby battery operation. In the normal mode, lamp will be illuminated. In the emergency mode, one lamp will provide emergency illumination for a minimum of 90 min. In accordance with U/L standrad #924. The test switch and indicator light are provided for ceiling mounting near the fixture in a single gang switch box (provided).
5. When used in insulated ceilings, insulation must be kept off the unit and no closer than 3”from the unit on all sides.
6. Do not use this equipment for other than the intended use.
7. Install only in accordance with National Electrical Code and Local Regulatory Agencies requirements.
8. Installation and servicing to be performed only by qualified personnel.
Standard InstallationFigure 1.
Figure 2.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
SAFETY: When Using Electrical Equipment, basic saftey precautions should always be followed, including The following:
1. Pour éviter les décharges électriques et la décharge non intentionnelle de la pile, ne raccordez pas le connecteur de l'appareil avant que l'installation soit terminée. Tout juste avant de mettre l'alimentation CA sous tension, connectez le connecteur au boîtier à bouton simple.
ENTRETIEN
1. Ce luminaire fournit plus d'une source de sortie d'alimentation électrique. Pour réduire les risques de décharge électrique, débranchez les sources normales et d'urgence en mettant le circuit de dérivation CA hors tension et en déconnectant le connecteur de l'assemblage du indicateur de charge / bouton test.
2. La source d'urgence nécessite une source d'alimentation CA non commutée de 120 ou 277 volts. Bouchez correctement le câble de sortie CA non utilisé. Consultez le schéma de câblage.
3. Cet appareil convient à un montage encastré au plafond uniquement. Ne l'utilisez pas à l'extérieur, dans des endroits à risque ou près d'un appareil de chauffage au gaz ou électrique.
4. Ceci est un appareil à ampoule fluorescente à montage encastré au plafond avec un fonctionnement à pile de secours. En mode normal, l'ampoule s'éclairera. En mode urgence, une seule ampoule fournira un éclairage d'urgence pendant 90 minutes minimum. Conformément au standard U/L N° 924 Le bouton test et le voyant indicateur sont fournis pour un montage au plafond près du luminaire dans un boîtier à bouton simple (fourni).
5. Lorsqu'il est utilisé dans des plafonds isolés, l'isolation ne doit pas se trouver à moins de 76 mm (3 po) de tous les côtés de l'appareil.
6. N'utilisez pas cet équipement à d'autres fins que celles prévues.
7. Installez l'appareil conformément aux exigences du Code national de l'électricité et des organismes de réglementation locaux.
8. L'installation et l'entretien doivent seulement être effectués par du personnel qualifié.
Installation StandardFigure 1.
Figure 2.
IMPORTANT: Lisez attentivement avant d'installer le luminaire. Conservez pour une référence future.
SÉCURITÉ: Lorsque vous utilisez un appareil électrique, vous devez toujours respecter les mesures de sécurité de base, y compris les suivantes:
LIGNE CHARGÉE NON COMMUTÉE (BOUCHEZ LE CÂBLE DE SORTIE NON
UTILISÉ)
N° 3
N° 4
N° 1
N° 2
VOIR
TAB
LEA
U P
OU
R
CO
ULE
UR
DU
CÂ
BLE
BA
LLAST
BLANC
NOIR
VOYANT CHARGE
CÔTÉ MARQUÉ
RACCORD DU DISPOSITIF
LIGNE CHARGÉE NON COMMUTÉE (BOUCHEZ LE CÂBLE DE SORTIE NON
UTILISÉ)
JAUNE
JAUNE
JAU
NE
JAU
NE
N° 3
N° 4
N° 1
N° 2
NOIR 120 V
ORG 277 V
BLANC COMMUN
BLANC/NOIR
BLEU/BLANC
BLEU
BLE
U
ROUGE
RO
UG
E
RO
UG
E
JAUNE/NOIR
JAUNE/NOIR
JAUNE
JAUNE
JAUNE
MO
DU
LE D
'UR
GE
NC
E B
OD
INE
BOÎTIER À BOUTON SIMPLE AVEC PLAQUE
VIOLET
MARRON
ROUGE
BLANC
BLANC/NOIR
BLANC
VOYANT CHARGE
CÔTÉ MARQUÉ
RACCORD DU DISPOSITIF
BOUTON TESTROUGE
RO
UG
E
RO
UG
E
JAUNE
BLE
U
JAUNE
JAUNE
N° 1
N° 2
DOUILLES RONDES
DOUILLES CARRÉES
VOIR
TAB
LEA
U P
OU
R
CO
ULE
UR
DU
CÂ
BLE
BA
LLAST
BLE
U
BLE
U
GR
IS
GR
IS
JAU
NE
JAU
NE
Tableau de couleurs des câbles de ballasts
Câble N° Ballasts ESI Ballasts non ESI
N° 1, N° 2 BLEU ROUGE
N° 3, N° 4 ROUGE BLEU
+
-
+
-
NOIR
NOIR
NOIR
BLANC
BA
LLAST C
AU
RG
. BA
LLAST
11
Instrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial
Instrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial 701435 ADP140564 www.eaton.com
INSTALACIÓN
1. Para evitar descargas eléctricas y descargas no intencionales de las baterías, no una el conector de la unidad hasta finalizar la instalación. Inmediatamente antes de conectar la alimentación de CA, enganche el conector a la caja de interruptor de salida individual.
MANTENIMIENTO
1. Esta luminaria incluye más de una fuente de alimentación de energía de salida. Para disminuir los riesgos de descargas eléctricas, desconecte tanto la fuente normal como la de emergencia, desconectando el circuito de rama de CA y el conector del conjunto del interruptor del indicador de carga/prueba.
2. La fuente de emergencia requiere una fuente de energía de CA no conmutada de 120 o de 277 voltios. Tape debidamente cualquier conector de CA no utilizado. Consulte el diagrama de cableado.
3. Esta unidad es para montaje empotrado en techos solamente. No la utilice en exteriores, en ubicaciones peligrosas, ni cerca de estufas de gas o eléctricas.
4. Esta es una unidad fluorescente compacta de montaje empotrado en techos con la posibilidad de funcionamiento con una batería de reserva. En el modo normal, la lámpara estará iluminada. En el modo de emergencia, una lámpara brindará iluminación de emergencia durante 90 minutos como mínimo. De conformidad con el estándar de U/L N. ° 924. El interruptor de prueba y la luz indicadora se incluyen para el montaje en techo junto a la luminaria en una caja de interruptor de salida individual (incluida).
5. Cuando se utiliza en techos aislados, el aislamiento debe mantenerse alejado de la unidad y a no menos de 3” (76,20 mm) de la unidad desde todos sus lados.
6. No utilice este equipo para otro fin diferente al indicado.
7. Instale únicamente de conformidad con el Código Eléctrico Nacional y con los requerimientos de las agencias regulatorias locales.
8. Solo personal cualificado debe realizar la instalación y el servicio de mantenimiento.
Instalación estándarFigura 1.
Figura 2.
IMPORTANTE: Lea atentamente antes de instalar la luminaria. Conserve estas instrucciones para tenerlas como referencia futura.
SEGURIDAD: Cuando utilice equipos eléctricos, siempre debe seguir precauciones de seguridad básicas, incluidas las siguientes:
12
Instrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial
Instrucciones de instalación de la luminaria fluorescente de emergencia compacta, empotrada y de uso comercial 701435 ADP140564 www.eaton.com