Edilteco S.p.A. Via dell’Industria, 710 . 41038 San Felice sul Panaro (MO) Italy Tel. +39 0535 82161 . Fax +39 0535 82970 . www.edilteco.com I [email protected] Thermal Insulation & Chemicals Division © Copyright EDILTECO S.p.A. · Non authorized reproduction is forbidden SUPERLIGHT THERMAL INSULATING INERT MATERIAL FOR DRY BLOWING INTO AIR SPACES. Available equipment for blowing Politerm Wall / Wall Fix ISOLCAP LIGHT Premixed superlight thermal insulating mortar PRODUCT POLITERM WALL Superlight thermal insulating material for dry blowing into air spaces. FIX VARIANT (consolidated) in interspace: using the specific equipment that allows to blow the product, the thermal insula- ting inerts of Politerm Wall are blowed with a specific aggregate (approx. 2 Kg/m 3 of cosumption). Thanks to this solution once introduced, the beads are aggregated, avoiding their spillage in case of future interventions on the walls (realization of traces, perforations, etc.). PACKAGING AND STORAGE · Bag of 500 lt. · Do not store for long time under direct sunlight. FIELDS OF APPLICATION It is used for thermal insulations and fillings of air spaces and closed volumes in general. CONSUMPTION / YELD To fill a volume of 1 m 3 , 2 bags of Politerm Wall are necessary (Politerm Wall Fix: + 2 Kg/m 3 of consolidating). PREPARATION FOR BLOWING Before starting to blow Politerm Wall, you have to prepare suitable openings (holes of cm. 4 - 5) on the walls for the introduction of the product and the extraction of the air that is in the air spaces. · Extensions up to 4 ml: n° 3 openings. The openings must be done in the two corners and at the centre of the wall, in the highest position to guarantee the complete filling of the volume. · Extensions over 4 ml: at least one opening for every 2 ml. Throug the openings it would also be possible to check the maximum level of filling. BLOWING Use the specific equipment Politerm Wall Blow (suction/pumping gun) see Edilteco equipment, that allows to blow the product taking it directly from the bags and obtaining an approximative yield of 1 m³ in approx. 7 - 9 minutes (according to the building site conditions). The use of Politerm Wall Blow equipment, allows the blowing directly from the bags, avoiding the pouring off operations and conse- quent dispersion of product in the work areas. - FIX VARIANT: it is required a further equipment called POLITERM WALL BLOW FIX to blow the consolidating. This equipment will be connected to the same compressor used for the POLITERM WALL. CHARACTERISTICS · Specific weight of the introduced product: (POLITERM WALL 8 - 12 Kg/m 3 ) - (POLITERM WALL FIX 10 - 14 Kg/m 3 ). · Estimated thermal conductivity λ = 0,035 W/mK (according to the tamping and effective distribution of the inert material spread in the inside of the filled volume). · Equivalent thermal conductivity l eq_isol = 0,063 W/mK. BLOWING EQUIPMENT (POLITERM WALL) POLITERM WALL BLOW · Outside diameter pipe: 38 mm. · Internal diameter pipe: 25 mm. Composed of: · Pumping gun (rent supplied). · Compressor - min. capacity 3 bar (not supplied). POLITERM WALL / POLITERM WALL FIX Superlight thermal insulating material for dry blowing into air spaces