Plastic Wing Tip Plastic Wing Ribs Plastic Gusset Plastic Center Rib and Wing Mount 3mm Dupron Plastic Control Horns Plastic Tail Wheel and Stab Mount 1mm M.W. Axle 3mm (1/8") O.D. C.F Tube 1.5mm (1/16") C.F Rod Cabines 1/8"x1/4" Balsa T.E. 0.5mm x 3mm C.F. Reinforcement 1/8" Sq. BALSA 1.5mm (1/16") C.F Rod L.G. Legs Plastic Wheel, Retainer and Axle Bracket 1mm M.W. Axle Plastic L.G. Bracket and Receiver Mount Plastic Motor and Controller Mount Plastic Movable Battery Holder Plastic Servo Mounts
7
Embed
Plastic Control Horns Plastic Wing Tip Plastic Gusset ...
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Plastic Wing Tip
Plastic Wing Ribs
Plastic Gusset
Plastic Center Rib and Wing Mount
3mm Dupron
Plastic Control Horns
Plastic Tail Wheel and Stab Mount
1mm M.W. Axle
3mm (1/8") O.D. C.F Tube
1.5mm (1/16") C.F Rod Cabines
1/8"x1/4" Balsa T.E.0.5mm x 3mmC.F. Reinforcement1/8" Sq. BALSA
1.5mm (1/16")C.F Rod L.G.Legs
Plastic Wheel, Retainerand Axle Bracket
1mm M.W. AxlePlastic L.G. Bracketand Receiver Mount
Plastic Motor andController Mount
Plastic MovableBattery Holder
Plastic ServoMounts
100mmC. to C.
86mm
447 mm
Length 43mm
Length 50mm
Locate to Suite Servos
After gluing the two wing halfstogether drill through ribsusing pilot hole formed in root rib halfs.
Join wing halfs by carefully aligning andbeing sure the two root rib surfces areflush before using Cyanoacrylte thick foam safeglue.Wing dihedral is 8 deg. and is built into the root rib.
After gluing servo mount and receiver/landinggear mount in place drill through the upperfuselage tube wall using the pilot holes as a guideand glue cabines in place.
Battery Mount snaps on to fuselagIt can be glued in place after theCG is determined and the plane
is test flown. True length of Landing Gear legs is 95 mm.
1.0 to 2.5°
DO NOT GLUE the wing to thecabines until the plane has beentest flown. The cabines will/shouldbe a tight fit into the wing root rib.
Gymster V Assembly NotesDesigned By Carl Hock26" Wing Span03Feb2017
Glue root rib in place after removing wing from flat building board.