1 3 2 4 9 10 6 7 8 3-AXIS GIMBAL MANUAL ACCESSORIES (1) Post Set X1 (2) MORPHEUS H3D-360 Controller X 1 (3) MORPHEUS H3D-360 Gimbal Unit X 1 (4) USB Cable X 1 (5) Dampering Balls (Bigger) X 5 (6) Damping Balls X 5 (7) *Fastener Rings X 4 (8) *Rubber Rings X 4 (9) *PPM Control Cable X 1 (10) Gimbal Mount X1 PC SOFTWARE The S-BUS output comes with full functions which have been defined channel number: ● Channel 1: ROLL Control ● Channel 2: Return to Home(Center Point) ● Channel 3: TILT Control ● Channel 4: PAN Control ● Channel 5: Mode Switch(Head Following & Head Lock) Uses the USB adapter to connect with your PC, Normally the Windows can find the driver automatically, you could find the PORT number in the device Manager. Launch the TTR Morpheus Gimbal Assistant, choose the correct port number and click Connect. BEEP BEEP will be shouted after the connection succeed, the parameters will be read out automatically. More information can view the tutorial videos on our TTR official website (www.ttrobotix.com) or YouTube channel (https://www.youtube.com/user/ThunderTigerVideo) MORPHEUS H3D-360 for GOPRO 3-Axis Gimbal has been finished with all the adjustments before shipping from the factory. It means you just need a few assembly then you can use. Weight Stabilization frequency Input voltage(DC) TILT travel angle ROLL travel angle PAN travel angle 280g ( without GOPRO ) 5200Hz 7.4V ~ 22.2V ( 2S ~ 6S Lipo ) ±45 degree ±45 degree 360 degrees with unlimited rotation PARAMETERS Built-in AV output no need flight control system support. 7.4V ~ 22.2V ( 2S ~ 6S Lipo ) DC IN Connect to PC for firmware upgrading THIS SIDE MUST FACE UP 3.5mm Headset Interface with AV output Dual Control Connect to S-BUS receiver channel for control TILT, ROLL and PAN Single Control Connect to PPM receiver channel for TILT controlling and 360 degrees with unlimited rotation for PAN Controlling (2) Dual Control Only S-BUS output channel mode provides full functions. 2 receivers are required. THE RECOMMEND OPERATION METHODS: (1) Single Control Please Connect PWM cable for TILT Controlling and 360 degrees with unlimited rotation for PAN Controlling, The TILT and PAN controlling required two receiver AUX channel. 360 degrees with unlimited rotation for PAN Controlling: This feature controls the PAN Controlling, after the knob turn to the center point then gimbal will stop the rotation of the left or right.Turn the control knob left & right three times and center the knob, the gimbal will return to the original center position. It does not required to supply the power to the receiver when under dual control mode, the H3D-360 controller will supply the power to the receiver via the S-BUS. (1) Gains There are 2 gains, Position Gain and Acceleration Gain. ● Pos. Gain: Inclined the gimbal to one position slowly and watch the image is horizontal or not, if not just adjust the Pos. Gain. ● Acc. Gain: After adjusting the Pos. Gain, Inclined the gimbal to one position quickly and watch the image is horizontal in time, if not just adjust the Acc. Gain. The MORPHEUS H3D-360 has preload factory setting which is ready to install. Calibrate when necessary. THE PARAMETERS AS BELOW: CONNECTION INSTRUCTION *Depend on different package, the accessories are different. 5 No. AP0003