Part Replacement Leverage Biceps Curl Arm ROM Stop Kits

Part Replacement

STAR TRAC FITNESS 1 of 3 637-1504 Rev: A

Leverage Biceps Curl – Arm ROM Stop Kits

Leverage Biceps Curl (L-5001)

Parts Required:

• Leverage Right Arm Kit (PN: 731-5600-13-KT)

• Leverage Left Arm Kit (PN: 731-5601-13-KT)

Tools Required:

• Metric Hex Key Wrench Set or Specific Keys o 4 Hex Key o 5 Hex Key o 6 Hex Key

• Metric Socket Set or Specific Sockets o 10mm Socket

• Socket Ratchet (Corresponding to Socket Drive Size)

Instructions:

1. From the underside of the chest/arm pad (Fig. 1) remove the four button head cap screws using a 5mm hex key to take off the upholstery pad assembly.

Fig. 1

Part Replacement

STAR TRAC FITNESS 2 of 3 637-1504 Rev: A

2. From either left or right side arm – remove the center socket head cap screw (Fig. 2) using a 6mm hex key and

take off the chrome cap covering the center pivot shaft.

Fig. 2

3. Using the 10mm socket and 4mm hex key – remove the clocking shoulder bolt that runs thru the center of the

pivot shaft (Fig. 3) along with the corresponding nut and washers.

Fig. 3

Note: In the process of pulling out the shoulder bolt – Hold on

to the side counter balance¹ to

prevent a sudden rotation that may cut the kevlar belt.

1. Item not shown in image.

Part Replacement

STAR TRAC FITNESS 3 of 3 637-1504 Rev: A

4. Slide off whole arm assembly (Fig. 4) and verify the spacing machine washer remains on the pivot shaft to reuse

on new arm installation.

Fig. 4

5. Unpack the new corresponding arm assembly kit – notice the difference between the old & new arm assembly

kits.

Fig. 5

6. To install the new arm assembly – reverse the previous process from steps 4 to 2.

7. Repeat all the previous steps to remove and install the opposite side arm assembly.