Revised 9/2010 PART #256 - 257 - 258 1957 Horn Cap and Bel Air/210 Emblem Instruction Sheet 1/1 800.854.6911 • WWW.DANCHUK.COM • 3201 S. Standard Avenue, Santa Ana, CA 92705 1. First, remove the center horn cap. This is done by accessing the center cap screws, #10207, through the hole in two steering wheel spoke from the back side. 2. Now to install the #257 - Bel Air, or #258 - 210 emblem into your original or new #256 - horn cap you will need to heat an oven to 200 degrees. Place your horn cap in the oven and wait until it’s hot. Being careful not to burn yourself, insert the new plastic emblem in from the back and bed ing tabs over to lock them in place. A light tap on a small drift punch will be all you need. 3. Now install your new horn cap and emblem back onto the steering wheel. Note: See diagram below for other items you may need to get the assembly back to new condition. 258 - 210 Emblem 256 - Horn Cap only 256A - Horn Cap w/Bel Air Emblem 256 - Horn Cap w/210 Emblem 255 - Horn Ring Only 2693 - Washer 10207 Center Cap Screw Kit 15605 Nut 257 - Bel Air Emblem 258 - 210 Emblem 257 - Bel Air Emblem 256 - 210 /Bel Air Horn Cap