5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair https://my.alldata.com/repair/#/repair/article/41676/component/7885/itype/401/nonstandard/949386/selfRefLink/true 1/24 2006 Ford Five Hundred AWD V6-3.0L VIN 1 Vehicle > Transmission and Drivetrain > Continuously Variable Transmission/Transaxle > Service and Repair > Removal and Replacement > Installation - Transaxle > All Wheel Drive (AWD) PART 1 OF 2 Transaxle - All Wheel Drive (AWD) Special Tool(s)
24
Embed
PART 1 OF 2€¦ · 5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair ...
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair
2006 Ford Five Hundred AWD V6-3.0L VIN 1Vehicle > Transmission and Drivetrain > Continuously Variable Transmission/Transaxle > Service and Repair >Removal and Replacement > Installation - Transaxle > All Wheel Drive (AWD)
PART 1 OF 2
Transaxle - All Wheel Drive (AWD)
Special Tool(s)
5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair
Continuously Variable Chain Type Transmission Fluid are not interchangeable transmission fluids. The use of anyfluid other than what is recommended for this transmission will cause transmission damage.
CAUTION: If a new transaxle or a mechatronic main control valve body assembly is installed, the TCM will need to
be reflashed to the latest level calibration available. If the TCM is not reflashed, the wrench light on the dash mayilluminate and internal transaxle damage may occur.
NOTE: If the transaxle was overhauled or if installing a new transaxle and the transmission fluid cooler tubes have
not been flushed, flush the fluid cooler tubes at this time.
If the transaxle was overhauled or if installing a new transaxle and a new transmission fluid cooler has not been
5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair
installed, install a new fluid cooler at this time.
1. If installing a new transaxle, install the fluid level indicator and tube and the bolt. ^ Tighten to 10 Nm (89 inch lbs.).
2. If installing a new transaxle, install the transaxle insulator using new retainers. 3. If removed, clean the rear transaxle mount bolts using a wire brush and apply new threadlock to the threads.
5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair
4. If installing a new transaxle, install the rear transaxle support insulator. ^ Tighten to 55 Nm (41 ft. lbs.).
5. Prior to installing the original or a new transaxle, apply multi-purpose grease to the torque converter pilot hub. 6. Position the transaxle to the back of the engine.
5/21/2020 Part 1 of 2 (Continuously Variable Transmission/Transaxle) - ALLDATA Repair