PAI or PPI Header in Incoming and Outgoing SIP Calls Prior to the introduction of the PAI or PPI Header in Incoming and Outgoing SIP Calls feature, the P-Asserted-Identity (PAI) or the P-Preferred-Identity (PPI) privacy header was supported for outgoing calls at the global level. The PAI or PPI Header in Incoming and Outgoing SIP Calls feature is an enhancement to support PAI or PPI header for incoming and outgoing calls at the global level and dial-peer configuration mode. This module describes how to enable support for the PAI or the PPI privacy header in incoming and outgoing Session Initiation Protocol (SIP) requests or response messages. • Finding Feature Information for PAI or PPI Header in Incoming and Outgoing SIP Calls, page 1 • Contents, page 2 • Information About PAI or PPI Header in Incoming and Outgoing SIP Calls, page 2 • How to Configure PAI or PPI Header in Incoming and Outgoing SIP Calls, page 3 • Configuration Examples for PAI or PPI Header in Incoming and Outgoing SIP Calls, page 5 • Additional References, page 6 • Feature Information for Handling PAI or PPI Header in Incoming and Outgoing SIP Calls, page 7 Finding Feature Information for PAI or PPI Header in Incoming and Outgoing SIP Calls Your software release may not support all the features documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the Feature Information for Handling PAI or PPI Header in Incoming and Outgoing SIP Calls, on page 7. Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn . An account on Cisco.com is not required. SIP Configuration Guide, Cisco IOS Release 15M&T 1
8
Embed
PAI or PPI Header in Incoming and Outgoing SIP Calls - · PDF fileContents Information About P AI or PPI Header in Incoming and Outgoing SIP Calls PAI or PPI Header Overview...
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
PAI or PPI Header in Incoming and Outgoing SIPCalls
Prior to the introduction of the PAI or PPI Header in Incoming and Outgoing SIP Calls feature, theP-Asserted-Identity (PAI) or the P-Preferred-Identity (PPI) privacy header was supported for outgoing callsat the global level. The PAI or PPI Header in Incoming and Outgoing SIP Calls feature is an enhancementto support PAI or PPI header for incoming and outgoing calls at the global level and dial-peer configurationmode.
This module describes how to enable support for the PAI or the PPI privacy header in incoming and outgoingSession Initiation Protocol (SIP) requests or response messages.
• Finding Feature Information for PAI or PPI Header in Incoming and Outgoing SIP Calls, page 1
• Contents, page 2
• Information About PAI or PPI Header in Incoming and Outgoing SIP Calls, page 2
• How to Configure PAI or PPI Header in Incoming and Outgoing SIP Calls, page 3
• Configuration Examples for PAI or PPI Header in Incoming and Outgoing SIP Calls, page 5
• Additional References, page 6
• Feature Information for Handling PAI or PPI Header in Incoming and Outgoing SIP Calls, page 7
Finding Feature Information for PAI or PPI Header in Incomingand Outgoing SIP Calls
Your software release may not support all the features documented in this module. For the latest featureinformation and caveats, see the release notes for your platform and software release. To find informationabout the features documented in this module, and to see a list of the releases in which each feature is supported,see the Feature Information for Handling PAI or PPI Header in Incoming and Outgoing SIP Calls, on page7.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn . An account on Cisco.com is notrequired.
Information About PAI or PPI Header in Incoming and OutgoingSIP Calls
PAI or PPI Header OverviewFor incoming SIP requests or response messages, when the PAI or PPI privacy header is set, the SIP gatewaybuilds the PAI or PPI header into the common SIP stack, thereby providing support to handle the call datapresent in the PAI or PPI header. To process the data from the PAI or PPI header of incoming SIP calls, werecommend that you enable the asserted ID for the incoming dial peer.
For outgoing SIP requests or response messages, when the PAI or PPI privacy header is set, privacy informationis sent using the PAI or PPI header.
If the PAI or PPI asserted ID is not enabled either in dial-peer configuration mode or at the global level,the call data present in the PAI or PPI header of incoming SIP calls is ignored.
Note
Support for PAI or PPI Header at the Global LevelAt the global level, the support for the PAI or PPI header in incoming and outgoing calls is provided usingthe asserted-id command. The asserted-id command enables the support for generating the PAI or PPI header,or the Remote-Party-ID (RPID) or FROM header data, to populate outbound calling information.
Support for PAI or PPI Header in Dial-Peer Configuration ModeIn dial-peer configuration mode, the support for the PAI or PPI header in incoming and outgoing calls isprovided using the voice-class sip asserted-id command. The voice-class sip asserted-id command enablesthe support for generating the PAI or PPI header, or the Remote-Party-ID (RPID) or FROM header data, topopulate outbound calling information.
SIP Configuration Guide, Cisco IOS Release 15M&T2
PAI or PPI Header in Incoming and Outgoing SIP CallsContents
How to Configure PAI or PPI Header in Incoming and OutgoingSIP Calls
Configuring the PAI or PPI Privacy Header at the Global Level
SUMMARY STEPS
1. enable2. configure terminal3. voice service voip4. sip5. asserted-id {pai | ppi}6. end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enableStep 1
Example:
Router> enable
• Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Enters voice service VoIP configuration mode.voice service voip
Example:
Router(config)# voice service voip
Step 3
Enters voice service VoIP-SIP configuration mode.sip
Example:
Router(conf-voi-serv)# sip
Step 4
Configures the privacy header for incoming and outgoing SIPrequests and response messages.
http://www.cisco.com/cisco/web/support/index.htmlThe Cisco Support and Documentation websiteprovides online resources to download documentation,software, and tools. Use these resources to install andconfigure the software and to troubleshoot and resolvetechnical issues with Cisco products and technologies.Access to most tools on the Cisco Support andDocumentation website requires a Cisco.com user IDand password.
Feature Information for Handling PAI or PPI Header in Incomingand Outgoing SIP Calls
The following table provides release information about the feature or features described in this module. Thistable lists only the software release that introduced support for a given feature in a given software releasetrain. Unless noted otherwise, subsequent releases of that software release train also support that feature.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Table 1: Feature Information for PAI or PPI Header in Incoming and Outgoing SIP Calls
Feature InformationReleasesFeature Name
Prior to the introduction of the PAIor PPI Header in Incoming andOutgoing SIP Calls feature, thePAI or the PPI privacy header wassupported for outgoing calls atglobal level. The PAI or PPIHeader in Incoming and OutgoingSIP Calls feature is anenhancement to support the PAI orthe PPI privacy header forincoming and outgoing calls at theglobal level and dial-peerconfiguration mode.
The following commands wereintroduced or modified:asserted-id, voice-class sipasserted-id.
12.4(24)T 15.1(3)TPAI or PPI Header in Incoming andOutgoing SIP Calls