OVF Replibit Installation Guide

Deploying Replibit’s

VMWare OVF

www.replibit.com [email protected] 888.978.3610

System Setup

• Assign the target machine with:• 2 GB of RAM (for nested virtualization use 8 GB RAM)

• 300 GB harddrive (for the “C:” drive)

• 2 CPU Cores (for nested virtualization us 8 CPU Cores)

• Create Data Drives (requires at least one). For:• RAID 0 1 drive required

• RAID 5 3 drives required

• RAID 6 4 drives required

• NOTE: DO NOT start your machine until you followed the directions on the last page.


Download Replibit’s OVF

• Download link is:• http://replibit.net/isodownload/Replibit.zip

• Username is: replibit

• Password is: RepIs0#321


http://replibit.net/isodownload/Replibit.zip

Installing

• Follow the screen shots in the following pages to install

• For technical support• Email: [email protected]

• Website with knowledge base: http://replibit.kayako.com

• Phone 888.978.3610


mailto:[email protected]

http://replibit.kayako.com/









Configuring Vmware ESXi 5.1 Settings

Step 1: import OVF

Step 2: add the four below values

NOTE: Please add the four values below to the Virtual

Machine configuration parameters before starting it.

The values can be added from Edit Settings >

Advanced > General > Configuration Parameters

vcpu.hotadd = "FALSE"

featMask.vm.hv.capable = "Min:1"

vhv.enable = "TRUE"

disk.EnableUUID = "true"


OVF Replibit Installation Guide

Documents