Oscillations and Waves

Oscillations and Waves

Wave Properties

Reflection and Refraction

Terminology (define these in your own words)- Incident ray- Reflected ray- Refracted ray- Normal line- Angle of incidence / reflection / refraction- Interface or boundary

Law of reflection

angle of incidence = angle of reflection

Refraction

This is caused by a change in speed as a wave passes form one medium into another. It results in…

- change in direction

- change in wavelength ( as v = fλ )

When there is refraction of a wave such as light, part of the wave is also reflected. This results in a decrease in intensity of the transmitted (refracted) wave.

Refractive index

The degree of refraction of light at a boundary is measured by the refractive index, n. The greater the reduction in speed of the light, the greater the refractive index:

Experiment: Investigate the relationship between the angle of incidence and angle of refraction for light.

nm = cvm

nm = absolute refractive index of a medium, m (no unit)

c = speed of light in a vacuumvm = speed of light in medium

Snell’s Law

It can be shown that the relative refractive index of two materials is given by the formula…

1n2 = sin i sin r

Where light travels from material 1 into material 2. Here…i = angle of incidencer = angle of refraction

i

r

Material 1

Material 2

In the data booklet the angles of incidence and refraction are called θ1 and θ2.

It can further be shown that…

Note that this is written in the data booklet as…

1n2 = sinθ1 = v1 = n2 sinθ2 v2 n1

sinθ2 = v2 = n1 sinθ1 v1 n2

E.g. 1A wave travelling at 12cms-1 is incident upon a surface at an angle of 55° from the normal.

a. If the angle of refraction is 40°, determine the speed of the wave in the second medium.

b. If the initial wavelength is 6cm determine the frequency of the wave in the second medium.

sinθ2 = v2

sinθ1 v1

sin 40 = v2

sin 55 12v2 = 9.4 cms-1

In first medium: v = fλ f = v/λ = 0.12 / 0.06 = 2.0 Hz

Frequency does not change during refraction f = 2.0 Hz

E.g. 2For light travelling from water into glass, r=20°.

If nw = 1.33 and ng = 1.50, determine i (θ1).

sinθ2 = n1 sinθ1 n2

sin20 = 1.33 sinθ1 1.50

sinθ1 = 0.34 / 0.89

= 0.38

θ1 = sin-1 0.38

= 22.5°

Phase and WavefrontsIf two oscillating bodies are in phase, this means that they reach their maximum displacement at the same time. E.g. any two wave crests are in phase.

E.g. During refraction of a water wave:

(Youtube link)

A wavefront is a line joining adjacent points that are in phase.

DiffractionWhen a wave passes through a gap or edge of a barrier they spread out. This effect is called diffraction. (You tube link)

Superposition (interference)Whenever two waves of the same type meet at the same point, the total amplitude (displacement) at that point equals the sum of the amplitudes (displacements) of the individual waves.

(You tube link1 and link2)

For constructive interference at any point, wavefronts must be ‘in phase’ and their path difference must be a whole number of wavelengths:

path difference = nλFor destructive interference at any point, wavefronts are ‘π out of phase’ and their path difference is given by:

path difference = (n + ½) λ

Task: On your interference diagram…

i. Draw in lines of constructive and destructive interference

ii. Indicate the lines that join points…

a. in phase

b. 2π out of phase (path difference = λ)

c. 4π out of phase (path difference = 2λ)

d. 3π out of phase (path difference = 1.5λ)

Coherent wavesA stable pattern of interference is only obtained if the two wave sources are coherent.Two coherent wave sources…

i. have a constant phase difference,ii. thus produce waves with equal frequency.

Superposition links- PheT Sound (see jar file)- Superposition of two pulses- With editable wave equations- Creating a standing wave

SubtitleText

SubtitleText

SubtitleText

SubtitleText

SubtitleText

SubtitleText