Make yourself a cute triceratops by folding the long piece of paper inwards and outwards in order. You will need to have a lot of patience, but it will be well worth it! When you're finished, be sure to take good care of your new pet - display it with some other dinosaur friends, or use it as a bookmark. Assembly instructions Mountain fold (dotted line) *Make a mountain fold. Valley fold (dashed and dotted line) *Make a valley fold. Scissors line (solid line) *Cut along the line. You will need Scissors, a pencil or dried up pen (use it to score along the fold lines for a neater fold), a ruler (use it with the pencil or pen to score along the fold lines) [Caution] Glue, scissors, and other tools may be dangerous to young children so be sure to keep them out of the reach of young children. *You will be folding two layers of paper together, so use your fingertip or fingernail to make the folds as sharp as possible. Be careful, though, not to damage the paper with your fingers. Cut out the pattern, make a crease down the center and fold it in half. Front Back Folding both layers of paper, make creases on all the fold lines, and then fold it in half again. Next, fold inward and outward along the fold lines as shown. (Check the diagrams and photos if unsure.) Fold part of the tail first, to make it easier to fold. Mountain fold this part of the tail inwards. (Do the same for the other side.) Leave the tail like this, and then go to the head. Mountain fold this part inwards. (Do the same for the other side.) Mountain fold this part inwards. (Do the same for the other side.) Valley fold here, mountain fold here, and fit the top over the bottom. Valley fold here, mountain fold here, and fit the top over the bottom. Origami Triceratops : Folding Instructions