Certificate of Analysis Product Name: MyRemede 75 mg Shampoo Batch ID/Lot #: 111419D Extraction Type: Full Spectrum Hemp Extract Product Type: Shampoo Sample Weight: 190 g Tests Performed: Type of Test Test Facility Reported Date X Cannabinoid Profile Lightscale Labs X Heavy Metals Lightscale Labs X Residual Solvents Lightscale Labs X Microbials Lightscale Labs X Mycotoxins Lightscale Labs % = Percent (Weight of Analyte / Weight of Product) * Total THC = THC + (THCa *(0.877)) ** Total CBD = CBD + CBDa HEAVY METALS Mycotoxin MICROBIALS RESIDUAL SOLVENTS CHEMICAL RESIDUES Full analytic details available on subsequent pages. POTENCY 2019-11-19 2019-11-19 2019-11-19 2019-11-19 2019-11-19 Components Tested: Abamectin, Azoxystrobin, Bifenazate, Etoxazole, Imazalil, Imidacloprid, Malathion, Myclobutanil, Permethrin, Spinosad, Spiromesifen, Spirotetramat, Tebuconazole Components Tested: Arsenic, Cadmium, Lead, Mercury Impurities Tested: STEC, Salmonella, Yeast & Mold Components Tested: Acetone, Benzene, Butanes, Ethanol, Ethyl- Acetate, Heptanes, Hexanes, Isopropanol, Methanol, n-Pentane, Propane, Toluene, Xylenes Components Tested: Aflatoxin B1, Aflatoxin B2, Aflatoxin G1, Aflatoxin G2, Ochratoxin A 0.00% Total THC* CBD 32.66 mg CBDa 38.74 mg 70.4 mg Total CBD** THC Profile CBD Profile 70.4 mg Total Cannabinoids THCa (0 mg) Delta 9 THC (0 mg) CBDa (37.235 mg) CBD (32.865 mg) CBGa (0 mg) CBG (0 mg) CBCa (0 mg) CBC (0 mg) Cannabinoid Profile STATUS PASS STATUS PASS STATUS PASS STATUS PASS STATUS PASS
3
Embed
ORELAP #4112 R-5185-MyRemede Shampoo · Bryce Kidd, Ph.D. Lab Director Aaron Troyer Chief Science Officer This data cannot be used for OLCC or OHA compliance for usable marijuana
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Certificate of Analysis
Product Name: MyRemede 75 mg ShampooBatch ID/Lot #: 111419DExtraction Type: Full Spectrum Hemp ExtractProduct Type: ShampooSample Weight: 190 g
Tests Performed: Type of Test Test Facility Reported DateX Cannabinoid Profile Lightscale LabsX Heavy Metals Lightscale LabsX Residual Solvents Lightscale LabsX Microbials Lightscale LabsX Mycotoxins Lightscale Labs
% = Percent (Weight of Analyte / Weight of Product)* Total THC = THC + (THCa *(0.877)) ** Total CBD = CBD + CBDa
HEAVY METALS Mycotoxin
MICROBIALS RESIDUAL SOLVENTS
CHEMICAL RESIDUES
Full analytic details available on subsequent pages.
This data cannot be used for OLCC or OHAcompliance for usable marijuana or marijuanaproducts and is provided for Research andDevelopment purposes only. L S - 1 9 1 1 1 9 - 8 9
Lightscale Labs is accredited by ORELAP (Lab #4112) for analysis in compliance with OAR 333-064 and OAR 333-007. Results pertain to submitted samples only. Unless otherwise
noted, samples were received in good condition and Quality Control samples met acceptance criteria. This Certificate shall not be reproduced except in full, without the written
approval of Lightscale Labs. Results marked with an asterisk (*) are not within scope of accreditation and for informational purposes only. 1 of 2
J Reported result is an estimate - the value is less than the minimum calibration level but greater than the estimated detection limit (EDL)
U The analyte was not detected in the sample at the estimated detection limit (EDL)
E Exceeds calibration range
D Dilution data - result was obtained from the analysis of a dilution
B Analyte found in sample and associated blank
C Co-eluting compound
R Relative Percent Difference (RPD) outside control limits
NR Analyte not reported because of problems in sample preparation or analysis
ND Non-Detect
X Results from reinjection/repeat/re-column data
EMC Estimated maximum possible concentration - indicates that a peak is detected but did not meet the method required criteria
M Manual integration
PS Peaks split
HB Control acceptance criteria are exceeded high and the associated sample is below the detection limit
LB Control acceptance criteria are exceeded low and the associated sample exceeds the regulatory limit
ME Marginal Exceedance
LR Low Recovery Analyte
LOQ Limit of Quantitation
Lightscale Labs is accredited by ORELAP (Lab #4112) for analysis in compliance with OAR 333-064 and OAR 333-007. Results pertain to submitted samples only. Unless otherwise
noted, samples were received in good condition and Quality Control samples met acceptance criteria. This Certificate shall not be reproduced except in full, without the written
approval of Lightscale Labs. Results marked with an asterisk (*) are not within scope of accreditation and for informational purposes only. 2 of 2