7/29/2019 Optimization_xACP
1/13
OPTIMI xACP
Basic characteristics &
Usability
7/29/2019 Optimization_xACP
2/13
i. Mainly focus area Coverage Optimization
Power Resource Utilization:
Buy one, use 1: good Utilization
Buy one, use 0.5 : bad Utilization
Keep Balancing in:
Coverage
Quality Traffic
7/29/2019 Optimization_xACP
3/13
ii. xACP gain: Stay in CIT, workinternational
Reducing Overshooting Improve Capacity, Throughput
Optimization work Reduce DCR, improve CSSR, improve Traffic, improve Throughput
mainly by the improvement of 3G signal quality.
Show Coverage hole, PP areareplace DT, from CIT could ckech
remotely
Concentration Administration in Site physical information: m-Tilt, e-tilt,Height, Lat, Lon, Remote management from Abroad
Issue new site location in Networkexpanding Network
7/29/2019 Optimization_xACP
4/13
iii. xACP output M-Tilt, E-Tilt, Antenna Height, Azimuth: tunning base onKPI report
Neighbor Optimization:Add, Remove neighbor base onCell performance
Add new site: recommend new site location base on Actual
Coverage
PSC plan: re-planning for PSC
7/29/2019 Optimization_xACP
5/13
OSS-calibrated predictions UMTS2100 Dominance: Baseline
Dominance geo maps shows the total number of interferes at each geo point. The satisfactorydominance should not exceed the value of 3
7/29/2019 Optimization_xACP
6/13
OSS-calibrated predictions UMTS2100 Dominance: Optimized
Dominance geo maps shows the total number of interferes at each geo point. The satisfactory
dominance should not exceed the value of 3
7/29/2019 Optimization_xACP
7/13
OSS-calibrated UMTS2100: RSCP_Baseline
Prediction based on the demand grid using CM & PM data in Baseline Configuration
7/29/2019 Optimization_xACP
8/13
OSS-calibrated UMTS2100: RSCP_Optimization
Prediction based on the demand grid using CM & PM data in Optimization Configuration
7/29/2019 Optimization_xACP
9/13
Ec/Io Baseline
True is current Ec/Io of network (threshold -13) & false means bad Ec/Io than threshold
7/29/2019 Optimization_xACP
10/13
Ec/Io Optimization
There is improvement in the slide above as True area is increases
7/29/2019 Optimization_xACP
11/13
Traffic Map based on propagation delay
Traffic distribution based on the CM & PM data
7/29/2019 Optimization_xACP
12/13
OSS-calibrated predictions UMTS2100: Coverage Analysis
Combined
Coverage RSCP /
EcIo
RSCP EcIo Dominance
< RSCP = -104
dBm / EcIo = -14
RSCP
7/29/2019 Optimization_xACP
13/13
iv. xACP input requirement
Map 20m resolution: Asset format
OSS data: CM (Configuration), PM (Counter), WNSC(neighbor)Stay in Vietnam, work for Abroad
Physical Site Data: Tilt, Height, Azimuth, Lat, Lon, (must
be correct as much as possible)